Direct determination of the area function for nanoindentation experiments
Open Access
- 5 February 2021
- journal article
- research article
- Published by Springer Nature in Journal of Materials Research
- Vol. 36 (11) , 2154-2165
Abstract
The determination of a suitable correction for tip blunting is crucial in order to obtain useful mechanical properties from nanoindentation experiments. While typically the required area function is acquired from the indentation of a reference material, the direct imaging by suitable methods is an interesting alternative. In this paper, we investigate the applicability of confocal laser scanning microscopy (CLSM), atomic force microscopy (AFM), and self-imaging by scanning a sharp silicon tip using the scanning probe microscopy extension of the nanoindentation system and compare the results to the area function obtained by the indentation of fused silica. The important tip characteristics were determined by various methods based on the analysis of the obtained 3D data sets. It was found that the suitability of CLSM and AFM depend on the resolution and the operation mode, respectively. While for these methods only limited consistency of the determined tip characteristics was found, self-imaging resulted in an excellent overall agreement.GraphicKeywords
Funding Information
- Christian Doppler Forschungsgesellschaft
- Montanuniversität Leoben
This publication has 29 references indexed in Scilit:
- The sharpness of a Berkovich indenterJournal of Materials Research, 2010
- Calibration issues for nanoindentation experiments: Direct atomic force microscopy measurements and indirect methodsMicroscopy Research and Technique, 2010
- Higher accuracy analysis of instrumented indentation data obtained with pointed indentersJournal of Physics D: Applied Physics, 2008
- The indenter tip radius effect in micro- and nanoindentation hardness experiments.Acta Mechanica Sinica, 2006
- Measuring tip shape for instrumented indentation using atomic force microscopyMeasurement Science and Technology, 2005
- Measurement of hardness and elastic modulus by instrumented indentation: Advances in understanding and refinements to methodologyJournal of Materials Research, 2004
- Progress in determination of the area function of indenters used for nanoindentationThin Solid Films, 2000
- A critical examination of the fundamental relations used in the analysis of nanoindentation dataJournal of Materials Research, 1999
- An improved technique for determining hardness and elastic modulus using load and displacement sensing indentation experimentsJournal of Materials Research, 1992
- Marching cubes: A high resolution 3D surface construction algorithmACM SIGGRAPH Computer Graphics, 1987