Influence of the Smoke-Layer Height and Temperature on Fire Spread Along a Single Cable Tray in a Compartment
Open Access
Abstract
An experimental study was conducted to quantitatively assess the separate effects of smoke-layer height and temperature on fire spread along a cable tray in a compartment. Smoke-layer height was controlled by varying the opening height (h) using side-wall configurations (SW0%, SW25%, and SW50%), while smoke-layer temperature was adjusted by changing the heat release rate (HRR) of an LPG burner (10, 14, and 18 kW). Fire spread was quantified using flame imaging and measurements of HRR, fire growth and spread rates, incident heat flux at tray height, and gas temperature and O2 concentration above and below the tray. At 10 kW, self-extinction occurred before the flame reached the tray end for all side-wall configurations. At 14 and 18 kW, fire spread to the tray end occurred under SW25% and SW50%. For a given HRR, SW50% produced higher heat flux and temperature near the tray but lower oxygen concentration, especially below the tray. These findings indicate that cable tray fire spread is governed by the combined effects of smoke-layer height and temperature through thermal feedback and local oxygen availability. Fire spread was promoted by stronger thermal feedback, but could be limited under a deeper smoke layer when oxygen availability near the tray was reduced.Keywords
Funding Information
- Korea Electric Power Corporation (R24XO01-5)
This publication has 13 references indexed in Scilit:
- CFD Simulations of Fire Propagation in Horizontal Cable Trays Using a Pyrolysis Model with Stochastically Determined GeometryFire Technology, 2022
- Experimental study on fire characteristics in cable compartment of utility tunnel with natural ventilationPLOS ONE, 2022
- Development and calibration of reduced-size plate thermometer for measuring incident heat fluxJournal of Fire Sciences, 2020
- Horizontal cable tray fire in a well‐confined and mechanically ventilated enclosure using a two‐zone modelFire and Materials, 2019
- Cable tray fire tests in a confined and mechanically ventilated facilityFire and Materials, 2017
- Investigation of the Flammability of Different Cables Using Pyrolysis Combustion Flow CalorimeterProcedia Engineering, 2013
- Probabilistic simulation of cable performance and water based protection in cable tunnel firesNuclear Engineering and Design, 2011
- IEEE Standard for Flame Testing of Cables for Use in Cable Tray in Industrial and Commercial Occupancies2008
- IEEE Standard for Qualifying Class 1E Electric Cables and Field Splices for Nuclear Power Generating Stations2008
- Measuring rate of heat release by oxygen consumptionFire Technology, 1991