Comparison of heat pump performance using fin-and-tube and microchannel heat exchangers under frost conditions
Authors:
- Liang-Liang ShaoLSLiang-Liang Shao
- Liang YangLYLiang Yang
- Chun-Lu ZhangCZChun-Lu Zhang
- 1 April 2010
- journal article
- Published by Elsevier in Applied Energy
- Vol. 87 (4) , 1187-1197
Abstract
No abstract availableThis publication has 23 references indexed in Scilit:
- A study on the performance of the airside heat exchanger under frosting in an air source heat pump water heater/chiller unitInternational Journal of Heat and Mass Transfer, 2004
- An exact solution to steady heat conduction in a two-dimensional slab on a one-dimensional fin: application to frosted heat exchangersInternational Journal of Heat and Mass Transfer, 2004
- Frost formation on fin- and- tube heat exchangers. Part II—Experimental investigation of frost formation on fin- and- tube heat exchangersInternational Journal of Refrigeration, 2004
- Frost formation on fin-and-tube heat exchangers. Part I—Modeling of frost formation on fin-and-tube heat exchangersInternational Journal of Refrigeration, 2004
- Dimensionless correlations of frost properties on a cold plateInternational Journal of Refrigeration, 2004
- Air-side thermal hydraulic performance of multi-louvered fin aluminum heat exchangersInternational Journal of Refrigeration, 2002
- R-744 gas cooler model development and validationInternational Journal of Refrigeration, 2001
- Technical Note A heat transfer and friction correlation for wavy fin-and-tube heat exchangersInternational Journal of Heat and Mass Transfer, 1999
- Evaporation heat transfer and pressure drop of refrigerant R-134a in a small pipeInternational Journal of Heat and Mass Transfer, 1998
- A general correlation for flow boiling in tubes and annuliInternational Journal of Heat and Mass Transfer, 1986