Practical Insulation Testing of 10 kV SiC MOSFET Modules
Authors:
- 29 October 2023
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 5517-5524
Abstract
This study aims to develop an additional screening process to select reliable power modules, as multiple modules experienced insulation failure during previous converter qualification steps despite passing static device characterization and the manufacturer’s end-of-line (EOL) baseplate isolation and partial discharge (PD) testing. DC and PWM soak tests were conducted where the modules were left to dwell under the specified voltage excitation. The testing procedure involved applying the excitation in timed increments of approximately 1-hour, then measuring the partial discharge inception voltage (PDIV) after each step until the final target soaking voltage was reached or the PDIV fell below the operational threshold. Out of 24 half-bridge modules tested, 87% passed dc soaking test, while only 44% passed PWM soaking. The modules that failed under PWM soak also failed at a much lower voltage than those that failed under dc soak; indicating that PWM soak tests have greater stress on module insulation. This highlights the importance of using various stress tests to assess insulation health and integrity.Keywords
Funding Information
- U.S. Department of Energy
This publication has 10 references indexed in Scilit:
- A 10 kV SiC Power Module Stacked Substrate Design with Patterned Middle-layer for Partial Discharge Reduction2023
- Multi-Objective Parametric Analysis of EV Traction Inverter between Reliability and Efficiency2023
- Design and Testing of a 13.8 kV/1.1MVA 3-Phase 5-Level Flying Capacitor Converter with 10 kV SiC MOSFETs2023
- Improved Power Density of a 6 kV, 1 MW Power Electronics Building Block Through Insulation Coordination2022
- High Power Density 10 kV SiC MOSFET-Based Modular, Scalable Converter for Medium Voltage Applications2022
- A Three-Phase Active-Front-End Converter System Enabled by 10-kV SiC MOSFETs Aimed at a Solid-State Transformer ApplicationIEEE Transactions on Power Electronics, 2021
- Power Cell Design and Assessment Methodology Based on a High-Current 10-kV SiC MOSFET Half-Bridge ModuleIEEE Journal of Emerging and Selected Topics in Power Electronics, 2020
- Partial Discharge Inception Voltage in DC insulation systems: a comparison with AC voltage supply2019
- Development of a highly integrated 10 kV SiC MOSFET power module with a direct jet impingement cooling system2018
- Design of a novel, high-density, high-speed 10 kV SiC MOSFET module2017