Tribological Properties of Chromia and Chromia Composite Coatings Deposited by Plasma Spraying
Open Access
Abstract
Cr2O3 and Cr2O3–SiO2-TiO2 coatings are deposited on P265GH steel using atmospheric plasma spraying. The influence of silicon oxide—titanium oxide addition on the surface morphology of the coatings, phase composition and tribological properties under non-lubricated sliding conditions are investigated. The addition of SiO2-TiO2 led to the formation of a more uniform surface morphology and reduce the surface roughness of the Cr2O3 coatings. The X-ray diffraction (XRD) studies indicated that both coatings are composed of an eskoloite Cr2O3 phase. The friction coefficients of the Cr2O3 coating are 0.504 and 0.431 when 1 N and 3 N loads were used, respectively. Meanwhile, the Cr2O3–SiO2-TiO2 coating demonstrated slightly lower values of friction coefficients under similar loads. The specific wear rate of the as-sprayed coating is reduced with the addition of SiO2-TiO2. It was found that the wear rates of the Cr2O3 and Cr2O3–SiO2-TiO2 coatings are up to 20 times lower compared to the steel substrate. This article is an expanded version of the “19th international conference on plasma physics and applications” conferenceKeywords
This publication has 27 references indexed in Scilit:
- Influence of TiO2 content on the mechanical and tribological properties of Cr2O3-based coatingMaterials & Design, 2015
- Structural characterization and mechanical properties of plasma sprayed nanostructured Cr2O3-Ag composite coatingsSurface and Coatings Technology, 2013
- Alternatives for hard chromium plating: Nanostructured coatings for severe-service valvesMaterials Chemistry and Physics, 2013
- Microstructure and properties of Al2O3/TiO2 nanostructured ceramic composite coatings prepared by plasma sprayingJournal of Alloys and Compounds, 2012
- Effect of critical plasma spray parameters on the microstructure, microhardness and wear and corrosion resistance of plasma sprayed alumina coatingsSurface and Coatings Technology, 2012
- Wear of Plasma Sprayed Conventional and Nanostructured Al2O3 and Cr2O3, Based CoatingsTransactions of the Indian Institute of Metals, 2011
- Preparation and characterization of nano TiO2/micron Cr2O3 composite particlesJournal of Alloys and Compounds, 2011
- Sliding wear characteristics of plasma-sprayed Al2O3 and Cr2O3 coatings against copper alloy under severe conditionsTribology International, 2010
- Influence of long-term aqueous exposure on surface properties of plasma-sprayed oxides Cr2O3 and Cr2O3–25 wt% TiO2Journal of Colloid and Interface Science, 2008
- Characterization of atmospheric plasma spray NiCr–Cr2O3–Ag–CaF2/BaF2 coatingsSurface and Coatings Technology, 2005