A novel wet extrusion technique to fabricate self‐assembled microfiber scaffolds for controlled drug delivery
- 24 May 2012
- journal article
- research article
- Published by Wiley in Journal of Biomedical Materials Research Part A
- Vol. 100A (10) , 2793-2802
Abstract
We have developed a novel wet extrusion process to fabricate nonwoven self‐assembled microfiber scaffolds with uniform diameters less than 5 μm and without any postmanipulation. In this method, a poly(L‐lactic acid) solution flows dropwise into a stirring nonsolvent bath, deforming into liquid polymer streams that self‐assemble into a nonwoven microfiber scaffold. The ability to tune fiber diameter was achieved by decreasing polymer spin dope concentration and increasing the silicon oil to petroleum ether ratio of the nonsolvent spin bath. To demonstrate the drug delivery capabilities of scaffolds, heparin was encapsulated using a conventional water‐in‐oil (W/O) emulsion technique and a cryogenic emulsion technique developed in our laboratory. Spin dope preparation was found to significantly effect the release kinetics of self‐assembled scaffolds by altering the interconnectivity of pores within the precipitating filaments. After 35 days, scaffolds prepared from W/O emulsions released up to 45% encapsulated heparin, whereas nearly 80% release of heparin was observed from cryogenic emulsion formulations. The versatility of our system, combined with the prolonged release of small molecules and the ability to control the homogeneity of self‐assembling scaffolds, could be beneficial for many tissue regeneration and engineering applications. © 2012 Wiley Periodicals, Inc. J Biomed Mater Res Part A 100A: 2793–2802, 2012.Keywords
This publication has 30 references indexed in Scilit:
- Gravity spun polycaprolactone fibres: controlling release of a hydrophilic macromolecule (ovalbumin) and a lipophilic drug (progesterone)Biomaterials, 2004
- Bioresorbable nanofiber‐based systems for wound healing and drug delivery: Optimization of fabrication parametersJournal of Biomedical Materials Research Part B: Applied Biomaterials, 2004
- Gravity spinning of polycaprolactone fibres for applications in tissue engineeringBiomaterials, 2004
- Technique Paper for Wet-Spinning Poly(L-lactic acid) and Poly(DL-lactide-co-glycolide) Monofilament FibersTissue Engineering, 2003
- Release of tetracycline hydrochloride from electrospun poly(ethylene-co-vinylacetate), poly(lactic acid), and a blendJournal of Controlled Release, 2002
- Synthetic nano-scale fibrous extracellular matrixJournal of Biomedical Materials Research, 1999
- Nanometre diameter fibres of polymer, produced by electrospinningNanotechnology, 1996
- Biodegradable fibresJournal of Materials Science: Materials in Medicine, 1994
- Tissue EngineeringScience, 1993
- Biodegradable materials of poly(l-lactic acid): 1. Melt-spun and solution-spun fibresPolymer, 1982