Effect of Heat Treatments on Microstructural Evolution and Tensile Properties of 15Cr12MoVWN Ferritic/Martensitic Steel
Open Access
Abstract
In this study, the phase transformation temperature of 15Cr12MoVWN ferritic/martensitic steel was determined by differential scanning calorimetry to provide a theoretical basis for the design of a heat treatment process. An orthogonal design experiment was performed to investigate the relationship between microstructure and heat treatment parameters, i.e., normalizing temperature, cooling method and tempering temperature by evaluating the room-temperature and elevated-temperature tensile properties, and the optimum heat treatment parameters were determined. It is shown that the optimized heat treatment process was composed of normalizing at 1050 °C followed by air cooling to room temperature and tempering at 700 °C. Under the optimum heat treatment condition, the room-temperature tensile properties were 1014 MPa (UTS), 810.5 MPa (YS) and 18.8% (elongation), while the values are 577.5 MPa (UTS), 469 MPa (YS) and 39.8% (elongation) tested at 550 °C. The microstructural examination shows that the strengthening contributions from microstructural factors were the martensitic lath width, dislocations, M23C6, MX and grain boundaries of prior austenite grain (PAG) in a descending order. The main factors influencing the tensile strength of 15Cr12MoVWN steel were the martensitic lath width and dislocations.Keywords
Funding Information
- National Key Technology R&D Program, China; Natural Science Foundation Guidance Plan of Liaoning Province (No. 149601A- A033; No. 2019-ZD-0362)
This publication has 35 references indexed in Scilit:
- Metallography studies and hardness measurements on ferritic/martensitic steels irradiated in STIPJournal of Nuclear Materials, 2008
- Ferritic/martensitic steels for next-generation reactorsJournal of Nuclear Materials, 2007
- Influence of high dose neutron irradiation on microstructure of EP-450 ferritic–martensitic steel irradiated in three Russian fast reactorsJournal of Nuclear Materials, 2004
- Creep rupture properties of nitrogen added 10Cr ferritic/martensitic steelsJournal of Nuclear Materials, 2004
- Impurity effects on reduced-activation ferritic steels developed for fusion applicationsJournal of Nuclear Materials, 2000
- Fracture toughness and tensile behavior of ferritic–martensitic steels irradiated at low temperaturesJournal of Nuclear Materials, 1998
- Liquid metal embrittlement susceptibility of welded MANET II (DIN 1.4914) in liquid Pb-17Li.Journal of Nuclear Materials, 1996
- The surface rate constants of deuterium in the martensitic steel DIN 1.4914 (MANET)Journal of Nuclear Materials, 1995
- The influence of radiation on the properties of welds and jointsJournal of Nuclear Materials, 1988
- The application of martensitic stainless steels in long lifetime fusion first wall/blanketsJournal of Nuclear Materials, 1979