Design of an AC Driving Waveform Based on Characteristics of Electrowetting Stability for Electrowetting Displays
Open Access
- 10 December 2020
- journal article
- research article
- Published by Frontiers Media SA in Frontiers in Physics
- Vol. 8
Abstract
In traditional electrowetting display (EWD) drivers, direct current (DC) voltage and pulse width modulation are often used, which easily caused an electrowetting charge trapping phenomenon in a hydrophobic insulating layer. Therefore, the driving voltage must be increased for driving EWDs, and oil backflow cannot be solved. Aqueous solutions are often used as polar liquids for EWDs, and the reverse voltage of alternating current (AC) driving can cause chemical reactions between water and indium tin oxide (ITO). So, a driving waveform was proposed, which included a DC waveform and an AC waveform, to separately drive EWDs for oil rupture and open state. Firstly, a DC waveform was used when the oil was broken, and the response time was reduced by designing the DC voltage and duration. Secondly, an AC waveform was used when the oil required to be stable. Oil backflow could be suppressed by the AC waveform. The main parameters of AC waveform include reverse voltage, frequency and duty cycle. The reverse voltage of EWDs could be obtained by voltammetry. The frequency could be obtained by analyzing the rising and falling edges of the capacitance voltage curve. The experimental results showed that the proposed waveform can effectively suppress oil backflow and shorten the response time. The response time was about 86% lower than the conventional driving waveforms, and oil backflow was about 72% slower than the DC driving waveform.Keywords
Funding Information
- National Key Research and Development Program of China (2016YFB0401502)
- Guangdong Innovative and Entrepreneurial Research Team Program (2019BT02C241)
- Special Project for Research and Development in Key areas of Guangdong Province (2019B010924002)
This publication has 28 references indexed in Scilit:
- Lightweight electrowetting display on ultra‐thin glass substrateJournal of the Society for Information Display, 2013
- Colored oil for electrowetting displaysJournal of Information Display, 2013
- Accurate‐gray‐level and quick‐response driving methods for high‐performance electrowetting displaysJournal of the Society for Information Display, 2011
- Electrowetting driven optical switch and tunable apertureOptics Express, 2011
- 10.3: Ultra low‐power Electrowetting‐based Displays Using Dynamic Frame Rate DrivingSID Symposium Digest of Technical Papers, 2011
- The effect of the oil/water interfacial tension on electrowetting driven fluid motionColloids and Surfaces A: Physicochemical and Engineering Aspects, 2005
- Liquid behavior inside a reflective display pixel based on electrowettingJournal of Applied Physics, 2004
- Video-speed electronic paper based on electrowettingNature, 2003
- Low voltage electrowetting-on-dielectricJournal of Applied Physics, 2002
- Determination of the half-wave potential of the species limiting the potential window. Measurement of gibbs transfer energies at the water/1,2-dichloroethane interfaceJournal of the Chemical Society, Faraday Transactions, 1991