Remotely floating wire-assisted generation of high-density atmospheric pressure plasma and SF6-added plasma etching of quartz glass
- 13 February 2019
- journal article
- conference paper
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 125 (6) , 063304
Abstract
High-density and large-volume atmospheric pressure plasma can be extended remotely by placing a long floating wire inside an Ar-gas flowing quartz tube connected with an inductively coupled coil. The discharge quartz tubes were categorized into three I-shaped tubes and one L-shaped tube. The influence of the geometrical design on plasma properties was investigated. Using the floating wire-assisted L tube, an electron density of 1014 cm−3 and a gas temperature less than 850 K were obtained at the downstream remote region. That is where the Ar plasma plume blew out from the slit at the bottom of the floating wire-assisted L tube at a distance of 140 mm from the coil center, when 100 W of a very high-frequency power (100 MHz) was applied to the inductively coupled coil. The applicability of this new L-type plasma source for large-area glass etching with a high etch rate was explored. At the remote region where the Ar plasma plume blew out of the slit of the L tube, SF6 gas was added for etching a quartz glass plate. Glass etching could be obtained over a large area of 15 mm × 20 mm with a maximum etch rate of 2 μm/min and a volume etch rate of 0.3 mm3/min.Keywords
This publication has 31 references indexed in Scilit:
- Reactive Evaporation of Metal Wire and Microdeposition of Metal Oxide Using Atmospheric Pressure Reactive Microplasma JetJapanese Journal of Applied Physics, 2006
- Maskless etching of microstructures using a scanning microplasma etcherThin Solid Films, 2006
- Atmospheric pressure plasmas: A reviewSpectrochimica Acta Part B: Atomic Spectroscopy, 2006
- Deep dry etching of borosilicate glass using SF6 and SF6/Ar inductively coupled plasmasMicroelectronic Engineering, 2005
- Computer simulated Balmer-alpha, -beta and -gamma Stark line profiles for non-equilibrium plasmas diagnosticsSpectrochimica Acta Part B: Atomic Spectroscopy, 2003
- An atmospheric pressure plasma sourceApplied Physics Letters, 2000
- GaAs Etch Rate Enhancement with SF[sub 6] Addition to BCl[sub 3] PlasmasJournal of the Electrochemical Society, 2000
- Submicrometer transmission mask fabricated by low-temperature SF6/O2 reactive ion etching and focused ion beamJournal of Vacuum Science & Technology B: Microelectronics and Nanometer Structures Processing, Measurement, and Phenomena, 1998
- The atmospheric-pressure plasma jet: a review and comparison to other plasma sourcesIEEE Transactions on Plasma Science, 1998
- SF 6, a Preferable Etchant for Plasma Etching SiliconJournal of the Electrochemical Society, 1981