Abstract
Ultraviolet (UV) light-emitting diodes (LEDs) are now widely used in analytical absorbance-based detectors, as compared to conventional UV lamps, they offer lower cost, faster response time, and higher photon conversion efficiency. However, cur-rent generation deep-UV-LEDs produce excess heat when operated at normal operating currents, which effects output stabil-ity, and reduces their overall performance and lifespan. Herein a 3D printed liquid cooling interface has been developed for a deep-UV-LED based optical detector, for capillary format flow through detection. The interface consists of a circular channel that is tightly wrapped around the LED to provide active liquid cooling. The design also facilitates easy plug-and-play assem-bly of the various essential components of the detector: specifically, a 255 nm UV-LED, a capillary Z-cell, and a broadband UV photodiode (PD). The unique liquid cooling interface improved the performance of the detector by reducing the LED tem-perature up to 22 °C, increasing the spectral output up to 34%, decreasing the required stabilisation time by up to sixfold, and reducing the baseline noise and limits of detection (LODs) by a factor of 2. The detector was successfully used within a capillary HPLC system, and could offer a miniaturised, rapidly stabilised, high sensitivity, and low-cost alternative to conven-tional UV detectors.
Funding Information
  • Australian Research Council (IC140100022)

This publication has 28 references indexed in Scilit: