Incremental and Bulk-fill Techniques With Bulk-fill Resin Composite in Different Cavity Configurations
Authors:
- 1 November 2018
- journal article
- research article
- Published by Operative Dentistry in Operative Dentistry
- Vol. 43 (6) , 631-641
Abstract
SUMMARY: Purpose: To compare the microtensile bond strengths of incremental and bulk-fill techniques under different C-factor and compliance conditions. Methods and Materials: Extracted human third molars were divided into three experimental groups. For group I, Class I cavities were prepared. For group II, MOD cavities of the same size were prepared. For group III, the cavities were prepared the same way as group II only with high compliance cavity walls. The cavity wall compliance of the specimens was evaluated. Each of these groups was divided into four subgroups. The teeth were restored using two different materials: TB (Tetric N-Ceram Bulk Fill; Ivoclar Vivadent, Hanau, Germany) and VB (Venus Bulk Fill; Heraeus Kulzer, Armonk, NY, USA), and two methods, either an incremental or bulk-fill technique. Then, the microtensile bond strengths (μ-TBSs) were measured and compared. The polymerization stresses of the composites were calculated using a custom-made device. The results were statistically analyzed using the Kruskal-Wallis test and Weibull analysis. Results: In group I, the μ-TBS obtained using the incremental technique was significantly higher than that obtained by the bulk-fill technique (p<0.05). In contrast, no difference of the μ-TBS value was observed between the two techniques in groups II and III. The μ-TBS value of group I was significantly lower than those of groups II and III (p0.05). Conclusions: The incremental technique showed higher bond strength than did the bulk-fill technique in high C-factor cavities. However, no difference was found between the two techniques in the low C-factor cavities. The bond strength in the high C-factor cavities was significantly lower than that of the low C-factor cavities.Keywords
This publication has 42 references indexed in Scilit:
- Placing Dental Composites—A Stressful ExperienceOperative Dentistry, 2008
- Axial shrinkage-stress depends upon both C-factor and composite massDental Materials, 2008
- Influence of instrument compliance and specimen thickness on the polymerization shrinkage stress measurement of light-cured compositesDental Materials, 2007
- Composite shrinkage stress as a function of specimen dimensions and compliance of the testing systemDental Materials, 2007
- Factors involved in the development of polymerization shrinkage stress in resin-composites: A systematic reviewDental Materials, 2005
- Does Layering Minimize Shrinkage Stresses in Composite Restorations?Journal of Dental Research, 2003
- Microtensile bond strengths of seven dentin adhesive systemsDental Materials, 2000
- Does an Incremental Filling Technique Reduce Polymerization Shrinkage Stresses?Journal of Dental Research, 1996
- Quantitative determination of stress reduction by flow in composite restorationsDental Materials, 1990
- Setting Stress in Composite Resin in Relation to Configuration of the RestorationJournal of Dental Research, 1987