Weld Formation in Laser Hot-Wire Welding of 7075 Aluminum Alloy
Open Access
Abstract
The laser hot-wire welding process was adopted to weld 7075 high-strength aluminum alloy. The influence laws of parameters on the weld formation were analyzed during laser hot-wire welding, and the microstructure characteristics and mechanical properties of welds were analyzed. The results showed that the parameters whose significance of influence on weld formation as ranked from high to low were laser power, current, gap width, welding speed and wire feeding rate. With the increase of wire temperature, the weld formation quality became better initially and then worse. Under the condition of optimized parameters, good weld formation could be obtained. The weld zone had a fine grain microstructure, and was in casting state consisted of dendritic crystal and equiaxed crystal. The heat affected zone mainly consisted of columnar crystal. The microhardness decreased gradually from base metal to heat affected zone then to weld zone. The tensile fracture of weld specimen occurred at the weld zone, and was in the ductile fracture state. The tensile strength of weld joint was 206 MPa and was 64.2% of base metal strength.Keywords
Funding Information
- National Natural Science Foundation of China (51505145)
This publication has 20 references indexed in Scilit:
- Microstructure, mechanical and corrosion behavior of high strength AA7075 aluminium alloy friction stir welds – Effect of post weld heat treatmentDefence Technology, 2015
- Microstructure, mechanical and tribological behavior of hot-pressed mechanically alloyed Al–Zn–Mg–Cu powdersMaterials & Design (1980-2015), 2015
- Experimental and numerical investigation of laser hot wire weldingThe International Journal of Advanced Manufacturing Technology, 2015
- Real-time monitoring of laser hot-wire cladding of Inconel 625Optics & Laser Technology, 2014
- Improvement of strategies and parameters for multi-axis laser cladding operationsOptics and Lasers in Engineering, 2014
- Butt welding of thick, high strength steel plate with a high power laser and hot wire to improve tolerance to gap variance and control weld metal oxygen contentScience and Technology of Welding and Joining, 2013
- Effect of minor Er and Zr on microstructure and mechanical properties of Al–Mg–Mn alloy (5083) welded jointsMaterials Science and Engineering: A, 2013
- Modelling of keyhole dynamics and porosity formation considering the adaptive keyhole shape and three-phase coupling during deep-penetration laser weldingJournal of Physics D: Applied Physics, 2011
- Development of High-efficiency / High-quality Hot-wire Laser Fillet Welding ProcessQUARTERLY JOURNAL OF THE JAPAN WELDING SOCIETY, 2011
- Microstructures in hot wire laser beam welding of HY 80 steelMaterials Science and Technology, 1994