Energy Optimization in Commercial FPGAs with Voltage, Frequency and Logic Scaling
- 20 May 2015
- journal article
- research article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Computers
- Vol. 65 (5) , 1484-1493
Abstract
This paper investigates the energy reductions possible in commercially available FPGAs configured to support voltage, frequency and logic scalability combined with power gating. Voltage and frequency scaling is based on in-situ detectors that allow the device to detect valid working voltage and frequency pairs at run-time while logic scalability is achieved with partial dynamic reconfiguration. The considered devices are FPGA-processor hybrids with independent power domains fabricated in 28 nm process nodes. The test case is based on a number of operational scenarios in which the FPGA side is loaded with a motion estimation core that can be configured with a variable number of execution units. The results demonstrate that voltage scalability reduces power by up to 60 percent compared with nominal voltage operation at the same frequency. The energy analysis show that the most energy efficiency core configuration depends on the performance requirements. A low performance scenario shows that serial computation is more energy efficient than the parallel configuration while the opposite is true when the performance requirements increase. An algorithm is proposed to combine effectively adaptive voltage/logic scaling and power gating in the proposed system and application.Keywords
Funding Information
- Engineering and Physical Sciences Research Council (EP/L00321X/1)
This publication has 16 references indexed in Scilit:
- Adaptive Voltage Scaling with In-Situ Detectors in Commercial FPGAsIEEE Transactions on Computers, 2014
- Dynamic voltage & frequency scaling with online slack measurement2014
- Cogeneration of Fast Motion Estimation Processors and Algorithms for Advanced Video CodingIEEE Transactions on Very Large Scale Integration (VLSI) Systems, 2011
- A sub-threshold FPGA with low-swing dual-VDD interconnect in 90nm CMOS2010
- RazorII: In Situ Error Detection and Correction for PVT and SER ToleranceIEEE Journal of Solid-State Circuits, 2008
- Clock-Aware Placement for FPGAs2007
- Heterogeneous routing architecture for low-power FPGA fabric2006
- Dynamic voltage scaling for commercial FPGAs2006
- Reducing leakage energy in FPGAs using region-constrained placement2004
- Low-power FPGA using pre-defined dual-Vdd/dual-Vt fabrics2004