Modeling parameters for the spectral behavior of infrared frequency-selective surfaces
- 1 January 2001
- journal article
- Published by Optica Publishing Group in Applied Optics
- Vol. 40 (1) , 118-124
Abstract
Comparisons of experiment and theory are presented for transmission spectra over the range 2–15 µm of a set of frequency-selective surfaces consisting of arrays of simple dipole patches of aluminum on or in silicon. The arrays are fabricated by direct-write electron-beam lithography. Important parameters controlling the spectral shape are identified, such as dipole length, spacing, resistance, and dielectric surroundings. The separate influence of these variables is exhibited. Encouraging agreement between simple model calculations and the measurements is found.Keywords
This publication has 23 references indexed in Scilit:
- Infrared optical constants and roughness factor functions determination: the HTHRTR methodApplied Optics, 1991
- Analysis of scattering from frequency-selective surfaces in the infraredJournal of the Optical Society of America A, 1990
- Frequency-selective surface using aperture-coupled microstrip patchesElectronics Letters, 1989
- Some effects of dielectric loading on periodic slot arraysIEEE Transactions on Antennas and Propagation, 1978
- Free-standing fine-wire grids: Their manufacture, performance, and use at millimeter and submillimeter wavelengthsJournal of the Optical Society of America, 1977
- Far infrared interference filtersJournal of Physics E: Scientific Instruments, 1977
- Transmission through a two-layer array of loaded slotsIEEE Transactions on Antennas and Propagation, 1974
- Variable Metal Mesh Coupler for Far Infrared LasersApplied Optics, 1970
- Metal Mesh Filters in the Far Infrared RegionJapanese Journal of Applied Physics, 1963
- Tunable Submillimeter Interferometers of the Fabry-Perot TypeIEEE Transactions on Microwave Theory and Techniques, 1963