Coconut-Fiber Composite Concrete: Assessment of Mechanical Performance and Environmental Benefits
Open Access
Abstract
The purpose of this qualification work is to study the physical and mechanical behavior of concrete with the addition of 0.5% and 1% coconut fiber, which has been subjected to two chemical treatments to reduce its degradation. The coconut fibers were extracted from the raw material and cut into pieces 4 cm long. Subsequently, the fibers were subjected to two chemical treatments. The first involved immersing the fibers in 4% sodium hydroxide (NaOH) solution, and the second treatment involved coating them with gum arabic and silica fume. A total of 50 samples of fibers were collected in their natural and post-treated state to be tested. The dosage was prepared for design strengths of 210 and 240 kg/cm2 (20.59 and 23.54 MPa), so that the percentages of 0.5% and 1% volume of coconut fiber, for the two treatments selected, replaced the respective volume of coarse aggregates. The cylinders with 1% addition of fibers had the best performance for the design strength of 20.59 MPa, including the cylinders without fibers. Those with 0.5% addition of fibers presented better performance for the 23.54 MPa dosage, although this was lower than the cylinders without fibers. In all cases, the cylinders with NaOH-treated fibers outperformed their counterparts with fibers treated with gum arabic and silica fume. Finally, a CO2 balance was determined, and an environmental gain up to 14 kg in CO2 emissions was established for each cubic meter of composite concrete.Keywords
This publication has 21 references indexed in Scilit:
- A new treatment for coconut fibers to improve the properties of cement-based composites – Combined effect of natural latex/pozzolanic materialsSustainable Materials and Technologies, 2017
- Readily implementable techniques can cut annual CO 2 emissions from the production of concrete by over 20%Environmental Research Letters, 2016
- Hydrophobic treatment of natural fibers and their composites—A reviewJournal of Industrial Textiles, 2016
- Effect of alkali treatment on microstructure and mechanical properties of coir fibres, coir fibre reinforced-polymer composites and reinforced-cementitious compositesConstruction and Building Materials, 2016
- Natural Fiber Composites2015
- Material and Structural Performance Evaluations of Hwangtoh Admixtures and Recycled PET Fiber-Added Eco-Friendly Concrete for CO2 Emission ReductionMaterials, 2014
- Correlation between the Diameter and the Density of Coir Fiber Using the Weibull Statistic MethodologyMaterials Science Forum, 2014
- The effect of sodium hydroxide treatment and fiber length on the tensile property of coir fiber-reinforced epoxy compositesScience and Engineering of Composite Materials, 2013
- Mechanical and dynamic properties of coconut fibre reinforced concreteConstruction and Building Materials, 2012
- Green house gas emissions due to concrete manufactureThe International Journal of Life Cycle Assessment, 2007