Heterodyne Eddy Current Testing Using Magnetoresistive Sensors for Additive Manufacturing Purposes
Authors:
Open Access
- 12 February 2020
- journal article
- research article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Sensors Journal
- Vol. 20 (11) , 5793-5800
Abstract
In recent years additive manufacturing technologies have become widely popular. For complex functional components or low volume production of workpieces, laser powder bed fusion can be used. High safety requirements, e.g. in the aerospace sector, demand extensive quality control. Therefore, offline non-destructive testing methods like computed tomography are used after manufacturing. Recently, for enhanced profitability and practicality online non-destructive testing methods, like optical tomography have been developed. This paper discusses the applicability of eddy current testing with magnetoresistive sensors for laser powder bed fusion parts. For this purpose, high spatial resolution giant magnetoresistance arrays are utilized for testing in combination with a single wire excitation coil. A heterodyne principle minimizes metrology efforts. This principle is compared to conventional signal processing in an eddy current testing setup using an aluminum test sample with artificial surface defects. To evaluate the influence of the powder used in the manufacturing process on eddy current testing and vice versa, a laser powder bed fusion mock-up made from stainless steel powder (316L) is used with artificial surface defects down to 100 μm. This laser powder bed fusion specimen was then examined using eddy current testing and the underlying principles.Keywords
Funding Information
- Bundesanstalt für Materialforschung und-prüfung within the focus area Materials
This publication has 14 references indexed in Scilit:
- Review of in-situ process monitoring and in-situ metrology for metal additive manufacturingMaterials & Design, 2016
- Live demonstration: A CMOS ASIC for precise reading of a Magnetoresistive sensor array for NDT2015
- Investigation into the effect of process parameters on microstructural and physical properties of 316L stainless steel parts by selective laser meltingThe International Journal of Advanced Manufacturing Technology, 2014
- Eddy currents testing probe with magneto-resistive sensors and differential measurementSensors and Actuators A: Physical, 2014
- GMR Magnetic Sensor Arrays for NDE Eddy-Current TestingAIP Conference Proceedings, 2003
- Spin-valve thermal stability: The effect of different antiferromagnetsJournal of Applied Physics, 2000
- EDGE CRACK DETECTION USING A GIANT MAGNETORESISTANCE BASED EDDY CURRENT SENSORNondestructive Testing and Evaluation, 2000
- Noise properties of ferromagnetic tunnel junctionsJournal of Applied Physics, 1998
- Enhanced magnetoresistance in layered magnetic structures with antiferromagnetic interlayer exchangePhysical Review B, 1989
- Giant Magnetoresistance of (001)Fe/(001)Cr Magnetic SuperlatticesPhysical Review Letters, 1988