Triaxial residual strains in a railway rail measured by neutron diffraction
- 25 June 2009
- journal article
- research article
- Published by SAGE Publications in The Journal of Strain Analysis for Engineering Design
- Vol. 44 (7) , 563-568
Abstract
Accumulation of residual stresses in rails during service can contribute to crack initiation and fracture and may result in serious accidents. It is therefore necessary and important to quantify the residual stresses that evolve under repeated rolling contact between wheel and rail. In the present study, triaxial residual strain measurements were performed in a worn British railway rail using neutron diffraction. Localized stress is observed close to the region of contact, showing the asymmetry and complexity of distributions that arise from the non-uniform plastic deformation. Contact-induced plasticity is revealed by the broadening (increase in the full width at half-maximum (FWHM)) of the diffraction peaks.Keywords
This publication has 10 references indexed in Scilit:
- Measurement of residual stresses in rails by neutron diffractionWear, 2008
- Neutrons and Synchrotron Radiation in Engineering Materials Science2008
- Variational eigenstrain analysis of residual stresses in a welded plateInternational Journal of Solids and Structures, 2007
- The new materials science diffractometer STRESS-SPEC at FRM-IIPhysica B: Condensed Matter, 2006
- An integrated approach for measuring near-surface and subsurface residual stress in engineering componentsThe Journal of Strain Analysis for Engineering Design, 2004
- Rail behaviour during cooling after hot rollingThe Journal of Strain Analysis for Engineering Design, 2004
- The Measurement of Residual Stress in Railway Rails by Diffraction and other MethodsJournal of Neutron Research, 2003
- Cyclic ratchetting and failure of a pearlitic rail steelFatigue & Fracture of Engineering Materials & Structures, 2000
- Residual stress changes in railway railsPhysica B: Condensed Matter, 1992
- Residual Stress in Rails1992