Effect of clays and calcium ions on bitumen extraction from athabasca oil sands using flotation
- 1 August 2000
- journal article
- research article
- Published by Wiley in The Canadian Journal of Chemical Engineering
- Vol. 78 (4) , 674-681
Abstract
A novel approach, based on the doping of rich estuarine oil sands with calcium and/or clays, was developed to study bitumen extraction. The batch flotation tests showed that the addition of either calcium ions up to 40 p.p.m., or kaolinite, illite and montmorillonite clays at 1 wt% of oil sands processed had marginal effect on bitumen recovery from the estuarine ores. A sharp reduction in bitumen recovery was observed only when calcium ions greater than 30 p.p.m. and 1 wt% montmorillonite clays were added together. While bitumen recovery correlated well with changes in water/air/bitumen contact angle, no correlation was found between bitumen recovery and measured zeta potential of clays or surface tension of the supernatants from the flotation slurry. The wettability of bitumen was identified as a key element in determining bitumen recovery. The aqueous solution analysis for calcium ions showed that most of the added calcium ions disappeared from the solution when montmorillonite clays were present. The addition of illite or kaolinite clays changed the calcium ion concentration in the slurry only marginally. Stronger adsorption of calcium ions on montmorillonite than on either kaolinite or illite is considered to be responsible for the increased bitumen wettability, and hence reduced bitumen recovery.Keywords
This publication has 13 references indexed in Scilit:
- Recovery, characterization and conceptual modelling of Non‐Bituminous organic materials from oil sandsThe Canadian Journal of Chemical Engineering, 1997
- Hot water extraction process mechanism using model oil sandsFuel, 1996
- The influence of mineral components on the generation of natural surfactants from Athabasca oil sands in the alkaline hot water processFuel Processing Technology, 1992
- The Physical Chemistry Of The Hot Water ProcessJournal of Canadian Petroleum Technology, 1988
- Two classes of anionic surfactants and their significance in hot water processing of oil sandsThe Canadian Journal of Chemical Engineering, 1987
- The influence of natural surfactants on interfacial charges in the hot-water process for recovering bitumen from the athabasca oil sandsColloids and Surfaces, 1985
- A Mechanism For Initiation of Bitumen Displacement From Oil SandJournal of Canadian Petroleum Technology, 1983
- Processibility of athabasca oil sand: Interrelationship between oil sand fine solids, process aids, mechanical energy and oil sand age after miningThe Canadian Journal of Chemical Engineering, 1983
- Surface-active agents in the aqueous phase of the hot-water flotation process for oil sandsFuel, 1978
- Water-soluble constituents of Athabasca bitumenFuel, 1977