Varus Tibial Joint Line Obliquity
Authors:
- 1 November 2001
- journal article
- section i-symposium
- Published by Wolters Kluwer Health in Clinical Orthopaedics and Related Research
- Vol. 392, 68-74
Abstract
In 60 consecutive total knee arthroplasties done in 52 patients with primary osteoarthritis and varus or neutral tibiofemoral alignment, the posterior condylar angle was calculated intraoperatively and averaged 3.98° (range, 0°–9°). Eighteen knees had a posterior condylar angle value less than 3° whereas 27 knees had a posterior condylar angle value of 5° or greater. Final rotational alignment of the femoral component was set parallel to the transepicondylar axis. Only one of these 60 knees required a lateral retinacular release for proper patellar tracking during the knee arthroplasty. When compared with three previously defined angles measured on the radiographs taken preoperatively, only the tibial plateau-tibial shaft angle values were correlated significantly with the value of the posterior condylar angle. As the tibial varus joint line obliquity increased, there was a distinct tendency for the transepicondylar axis to be rotated more externally relative to the posterior condylar axis. This variance suggests that the use of the posterior condylar axis as a rotational reference is inappropriate in many knees with arthritis with varus or neutral tibiofemoral alignment. In particular, varus tibial joint line obliquity of more than 4° increases the likelihood of femoral component malrotation when the posterior femoral condyles are used to reference femoral component rotation.Keywords
This publication has 16 references indexed in Scilit:
- Anatomy of the epicondyles of the distal femurThe Journal of Arthroplasty, 2000
- A comparison of 4 intraoperative methods to determine femoral component rotation during total knee arthroplastyThe Journal of Arthroplasty, 2000
- The Transepicondylar Axis Approximates the Optimal Flexion Axis of the KneeClinical Orthopaedics and Related Research, 1998
- The posterior condylar angle in osteoarthritic kneesThe Journal of Arthroplasty, 1998
- Reliability of the anteroposterior axis and the posterior condylar axis for determining rotational alignment of the femoral component in total knee arthroplastyJournal of Orthopaedic Science, 1998
- Femoral Rotational Alignment Using the Tibial Shaft Axis in Total Knee ArthroplastyClinical Orthopaedics and Related Research, 1996
- Rotational Landmarks and Sizing of the Distal Femur in Total Knee ArthroplastyClinical Orthopaedics and Related Research, 1996
- The Effects of Patellar Thickness on Patellofemoral Forces After ResurfacingClinical Orthopaedics and Related Research, 1996
- Morphology of the transepicondylar axis and its application in primary and revision total knee arthroplastyThe Journal of Arthroplasty, 1995
- Effect of rotational malposition of the femoral component on knee stability kinematics after total knee arthroplastyThe Journal of Arthroplasty, 1995