Effects of the geometrical features of flow paths on the flow capacity of a control valve trim
Authors:
- Taimoor AsimTaimoor Asim
- Rakesh MishraRakesh Mishra
- Antonio OliveiraAOAntonio Oliveira
- Matthew CharltonMCMatthew Charlton
- 1 January 2019
- journal article
- research article
- Published by Elsevier in Journal of Petroleum Science and Engineering
- Vol. 172, 124-138
Abstract
No abstract availableKeywords
This publication has 18 references indexed in Scilit:
- Computational fluid dynamics based optimal design of hydraulic capsule pipelines transporting cylindrical capsulesPowder Technology, 2016
- Optimal design of hydraulic capsule pipelines transporting spherical capsulesThe Canadian Journal of Chemical Engineering, 2016
- Optimal sizing and life-cycle cost modelling of pipelines transporting multi-sized solid–liquid mixturesInternational Journal of Pressure Vessels and Piping, 2014
- Optimal design of a four-sensor probe system to measure the flow properties of the dispersed phase in bubbly air–water multiphase flowsSensors and Actuators A: Physical, 2013
- Computational Fluid Dynamics based Fault Simulations of a Vertical Axis Wind TurbinesJournal of Physics: Conference Series, 2012
- Local Analysis of Flow Conditions within a Geometrically Complex Control Valve Trim using CFDJournal of Physics: Conference Series, 2012
- Validation of CFD predictions using process data obtained from flow through an industrial control valveJournal of Physics: Conference Series, 2012
- A computational fluid dynamic analysis on the effect of front row pin geometry on the aerothermodynamic properties of a pin-vented brake discProceedings of the Institution of Mechanical Engineers, Part D: Journal of Automobile Engineering, 2008
- Optimal design of a multi-stage capsule handling multi-phase pipelineInternational Journal of Pressure Vessels and Piping, 1998
- A calculation procedure for heat, mass and momentum transfer in three-dimensional parabolic flowsInternational Journal of Heat and Mass Transfer, 1972