Silane‐Modified Graphene Oxide as a Compatibilizer and Reinforcing Nanoparticle for Immiscible PP/PA Blends
- 8 November 2019
- journal article
- research article
- Published by Wiley in Polymer Engineering & Science
- Vol. 60 (1) , 180-191
Abstract
Graphene oxide (GO) and aminosilane (AS)‐modified GO (GOAS) have been studied as possible compatibilizers for immiscible polyblends. Ideally, for localization of nanoparticles (NPs) at the interface, the thermodynamics of the constituents and mixing dynamics have to be tailored and controlled, respectively. Accordingly, a variety of oxidation levels (10%–40%) of GOs were prepared using Hummer's method and further modified by AS. Experimental results indicated that the GO goes through thermal reduction (above 200°C) during blending and reduced GO (rGO) is produced. The GOAS moderated the reduction reaction and stabilized the GO. The thermodynamic wetting coefficient of PP (polypropylene)/PA (polyamide)/rGOAS system was shown to drive the rGOAS from the PP phase to the blend's interface during time‐controlled blending. The localization of the rGOAS at the interface resulted in significant enhancement of mechanical properties using only 2–3 wt% of rGOAS. Over 100% enhancement in strength, 40% enhancement in modulus, and 30% in toughness were shown, compared with neat PP/PA. Reduced GOAS and its location at the interface resulted in a third glass transition temperature (Tg), in addition to the PP and PA respective Tgs. Rheological percolation at 2–3 wt% rGOAS (20%) supports the localization of rGOAS at the interface. Storage moduli increase with interfacial tension, in accordance to the rheological models. POLYM. ENG. SCI., 60:180–191, 2020. © 2019 Society of Plastics EngineersKeywords
This publication has 37 references indexed in Scilit:
- Temperature-dependent compatibilizing effect of graphene oxide as a compatibilizer for immiscible polymer blendsRSC Advances, 2013
- Compatibilization of immiscible nylon 6/poly(vinylidene fluoride) blends using graphene oxidesPolymer International, 2012
- Compatibilization of Immiscible Polymer Blends Using Graphene Oxide SheetsACS Nano, 2011
- Chemically Derived Graphene Oxide: Towards Large‐Area Thin‐Film Electronics and OptoelectronicsAdvanced Materials, 2010
- Preparation, characterization and properties of binary and ternary blends with thermoplastic starch, poly(lactic acid) and poly(butylene adipate-co-terephthalate)Carbohydrate Polymers, 2009
- Graphite oxide/poly(methyl methacrylate) nanocomposites prepared by a novel method utilizing macroazoinitiatorComposites Science and Technology, 2009
- Role of organically modified layered silicate as an active interfacial modifier in immiscible polystyrene/polypropylene blendsPolymer, 2004
- Kinetics-controlled compatibilization of immiscible polypropylene/polystyrene blends using nano-SiO2 particlesPolymer, 2004
- Selective Localization of Carbon Black in Immiscible Polymer Blends: A Useful Tool To Design Electrical Conductive CompositesMacromolecules, 1994
- Preparation of Graphitic OxideJournal of the American Chemical Society, 1958