A Complex Review of the Possibilities of Residual Stress Analysis Using Moving 2D and 3D Digital Image Correlation System
Authors:
Open Access
- 1 September 2021
- journal article
- review article
- Published by Walter de Gruyter GmbH in Strojnícky časopis - Journal of Mechanical Engineering
- Vol. 71 (1) , 61-78
Abstract
Understanding the levels of residual stresses in the material is very important in predicting the service life of structural elements. One of the most widely used techniques to quantify them is the drilling method, where a small hole is milled in the structure. If the residual stresses are present, stress redistribution will occur, resulting in deformation of the hole surroundings. Nowadays, there is an effort to replace the conventionally used strain gauges, i.e. special strain gauge rosettes, with full-field optical experimental techniques. This paper deals with analysing the possibilities of measuring the relieved strains/stresses with a unique drilling/measuring device, which, unlike other non-commercial measuring systems, uses the moving digital image correlation (DIC) system. Since correlation systems do not tend to move during operation, an analysis was performed describing the effect of changing the position of the single and stereo camera correlation systems on the quality of the results of the strain/stress analysis performed in the vicinity of the milled hole. The conclusion from the analyses performed is that there is no significant accumulation of correlation errors during measurement. Therefore, the information on the magnitudes of the strains/stresses relieved obtained by the moving DIC system can be used to quantify the residual stresses with an expected error corresponding to the sensitivity of this full-field optical experimental technique.Keywords
This publication has 10 references indexed in Scilit:
- Design of a Unique Device for Residual Stresses Quantification by the Drilling Method Combining the PhotoStress and Digital Image CorrelationMaterials, 2021
- Development of the Device with a High Positioning Accuracy Serving for Residual Stress Quantification using Optical MethodsActa Mechanica Slovaca, 2019
- The Assessment of the Residual Stresses Influence on Generation of the Infringement in Shape-Complex Supporting MembersStrojnícky časopis - Journal of Mechanical Engineering, 2019
- Analysis of the aspects of residual stresses quantification performed by 3D DIC combined with standardized hole-drilling methodMeasurement, 2019
- THE ASPECTS OF STRESS ANALYSIS PERFORMED BY DIGITALIMAGE CORRELATION METHOD RELATED WITH SMOOTHING ANDITS INFLUENCE ON THE RESULTSActa Mechatronica, 2018
- Residual stress estimation based on 3D DIC displacement filed measurement around drilled holesProcedia Structural Integrity, 2018
- New Method of Residual Stress Evaluation and its Advantages in Comparison with More Common Hole-drilling MethodActa Mechanica Slovaca, 2013
- Practical Residual Stress Measurement Methods2013
- A portable digital speckle pattern interferometry device to measure residual stresses using the hole drilling techniqueOptics and Lasers in Engineering, 2006
- Hole-drilling strain-gage method of measuring residual stressesExperimental Mechanics, 1966