Dimensioning method for bolted, adhesively bonded, and hybrid joints involving Fibre-Reinforced-Polymers
Authors:
- Till ValléeTVTill Vallée
- Thomas TannertThomas Tannert
- Rahul MeenaRMRahul Meena
- Simon HehlSHSimon Hehl
- 1 March 2013
- journal article
- Published by Elsevier in Composites Part B: Engineering
- Vol. 46, 179-187
Abstract
No abstract availableKeywords
This publication has 35 references indexed in Scilit:
- A phenomenological analysis of Mode I fracture of adhesively-bonded pultruded GFRP jointsEngineering Fracture Mechanics, 2011
- Mixed-mode fracture of adhesively-bonded pultruded composite lap jointsEngineering Fracture Mechanics, 2010
- Probabilistic strength analysis of bolted joints in laminated composites using point estimate methodComposite Structures, 2009
- Composite behavior of hybrid FRP-concrete bridge decks on steel girdersComposite Structures, 2008
- Influence of bolt spacing and degree of anisotropy in single-lap jointsComputers & Structures, 2000
- Single-bolt tension joint tests on pultruded GRP plate — effects of tension direction relative to pultrusion directionComposite Structures, 1998
- Load distribution in composite multifastener jointsComputers & Structures, 1996
- Effects of joint geometry and bolt torque on the structural performance of single bolt tension joints in pultruded GRP sheet materialComposite Structures, 1995
- Bonded-bolted composite jointsJournal of Aircraft, 1985
- Stress analysis of adhesive-bonded lap jointsJournal of Strain Analysis, 1974