Metallographic and Mechanical Research of the O–Ti2AlNb Alloy
Open Access
Abstract
This paper provides the test results of the fatigue crack growth in notched specimens under tension. The tests were performed on plane specimens with external blunt two-sided notches at room temperature. The tested material was O–Ti2AlNb titanium alloy. The tests were carried out at constant load value and constant stress ratio R = 0. The tests were done at the fatigue stand Instron under the loading change frequency of 25 Hz. The results of mechanical and structural tests of the examined alloy were presented. Scanning electron microscopy (SEM) was used in metallography, which allowed for the initial identification of intermetallic phases. The development of fatigue cracks in the tested alloy indicates that there is a tendency for brittle fracturing, which ran along the grain boundary.Keywords
This publication has 23 references indexed in Scilit:
- Effect of an Al2O3 coating on the oxidation process of a γ-TiAl phase based alloyCorrosion Science, 2012
- Influence of oxygenation time on crack growth in titanium alloy under cyclic bendingMaterials Science, 2011
- An investigation on oxidation wear mechanisms of Ti–46Al–7Nb–0.7Cr–0.1Si–0.2Ni intermetallic-based alloysCorrosion Science, 2010
- A physically-based model for the prediction of long fatigue crack growth in Ti–6Al–4VMaterials Science and Engineering: A, 2001
- Gamma titanium aluminides as prospective structural materialsIntermetallics, 2000
- Oxidation of ductile particle reinforced Ti-48Al compositeMetallurgical and Materials Transactions A, 1995
- Effect of surface finish on fatigue strengthEngineering Fracture Mechanics, 1995
- Developing hydrogentolerant microstructures for an α2 titanium aluminide alloyMetallurgical Transactions A, 1992
- Neutron powder diffraction study of the orthorhombic Ti2AlNb phaseScripta Metallurgica et Materialia, 1990
- A new ordered orthorhombic phase in a Ti3AlNb alloyActa Metallurgica, 1988