Large‐eddy simulation of the flow in a low‐speed centrifugal compressor
- 18 February 2008
- journal article
- research article
- Published by Wiley in International Journal for Numerical Methods in Fluids
- Vol. 56 (8) , 1271-1280
Abstract
The results of a series of numerical simulations for the NASA low‐speed centrifugal compressor are presented. Large‐eddy simulation (LES) is carried out together with the most commonly used Reynolds‐averaged Navier–Stokes (RANS) models, including the mixing length, k–ε and k–ω models. Predictions are compared with the available experimental data. It is seen that quantitative predictions of LES are better than those of RANS models for the tip jet and wake regions. LES, unlike these RANS models and the past computational fluid dynamics predictions, shows separation near the casing starting around the halfway of the impeller and reveals a vortex bubble close the impeller exit/casing corner. The tip leakage flow, which is the main characteristic of an unshrouded compressor, is investigated using the probability density function (PDF) and the power spectral density (PSD) of the instantaneous velocity values. The skewness and flatness calculated from the PDF profiles show that the unsteady flow in the tip wake region is less‐intermittent compared with the flow in the tip jet region. The PSD analysis shows that the turbulent energy transfer rate from the larger scales to the smaller scales and the frequency range where the inertial region is valid increase in the tip wake region. Copyright © 2008 John Wiley & Sons, Ltd.Keywords
This publication has 12 references indexed in Scilit:
- Validation of large-eddy simulation of strongly curved stationary and rotating U-duct flowsInternational Journal of Heat and Fluid Flow, 2007
- Flow in a Centrifugal Pump Impeller at Design and Off-Design Conditions—Part II: Large Eddy SimulationsJournal of Fluids Engineering, 2003
- Analysis of Vortical Flow Field in a Propeller Fan by LDV Measurements and LES—Part I: Three-Dimensional Vortical Flow StructuresJournal of Fluids Engineering, 2001
- Turbulent Flows2000
- Subgrid-Scale Stress Modelling Based on the Square of the Velocity Gradient TensorFlow, Turbulence and Combustion, 1999
- Three-dimensional viscous flow simulation in a backswept centrifugal impeller at the design pointComputers & Fluids, 1996
- Experimental and Computational Investigation of the NASA Low-Speed Centrifugal Compressor Flow FieldJournal of Turbomachinery, 1993
- The ULTIMATE conservative difference scheme applied to unsteady one-dimensional advectionComputer Methods in Applied Mechanics and Engineering, 1991
- Instantaneous Measurements in the Jet-Wake Discharge Flow of a Centrifugal Compressor ImpellerJournal of Engineering for Power, 1975
- GENERAL CIRCULATION EXPERIMENTS WITH THE PRIMITIVE EQUATIONSMonthly Weather Review, 1963