Analysis of medium manganese steel through cold-rolling and intercritical annealing or warm-rolling
- 22 April 2018
- journal article
- research article
- Published by SAGE Publications in Materials Science and Technology
- Vol. 35 (17) , 2120-2133
Abstract
Medium manganese steel is typically fabricated from hot-rolling followed by cold-rolling and intercritical annealing processes. However, a singular process, warm-rolling, is an appealing prospect. The microstructure, mechanical properties and texture of a 8 wt-% Mn–0.08 wt-% C steel was investigated by cold-rolling followed by intercritical annealing or warm-rolling. The product from both processes exhibited a highly refined microstructure as well as a large volume fraction of austenite. However, a slightly larger volume fraction as well as a more heterogeneous austenite morphology resulted from the warm-rolling process, associated with a higher work-hardening rate. Microstructural analysis revealed intense α-fibre components due to a higher strain following the warm-rolling process as well as a considerably high-angle grain boundary number which was associated with dislocation accumulation. This paper is part of a Thematic Issue on Medium Manganese Steels.Keywords
Funding Information
- Conselho Nacional de Desenvolvimento Científico e Tecnológico (404303/2016-1)
This publication has 52 references indexed in Scilit:
- Significance of control of austenite stability and three-stage work-hardening behavior of an ultrahigh strength–high ductility combination transformation-induced plasticity steelScripta Materialia, 2013
- Development of Ultrafine Lamellar Ferrite and Austenite Duplex Structure in 0.2C5Mn Steel during ART-annealingISIJ International, 2011
- Designing Ultrahigh Strength Steels with Good Ductility by Combining Transformation Induced Plasticity and Martensite AgingAdvanced Engineering Materials, 2009
- The effect of aluminium and phosphorus on the stability of individual austenite grains in TRIP steelsActa Materialia, 2009
- Microstructure and texture of Nb + Ti stabilized ferritic stainless steelMaterials Characterization, 2008
- Effects of severe cold rolling on the texture and grain boundary character of a Ti–Nb IF steelMaterials Letters, 2008
- Microstructural and textural changes in a severely cold rolled boron-added interstitial-free steelScripta Materialia, 2007
- Effects of GBCD on cold work embrittlement of high strength interstitial free steelsMaterials & Design (1980-2015), 2006
- Microstructural Evolution of Ultra Fine Grained C-Mn Steel Warm Rolling and Intercritical AnneaMaterials Research, 2002
- The coincidence site lattice and the ‘sigma enigma’Materials Characterization, 2001