Pre‐treatment of titanium surfaces by fibronectin: in situ adsorption and effect of concentration
- 16 April 2010
- journal article
- research article
- Published by Wiley in Surface and Interface Analysis
- Vol. 42 (6-7) , 457-461
Abstract
In this work, kinetics data on adsorption of fibronectin (Fn) on passivated Ti surfaces (Ti quartz crystals) in phosphate buffered saline (PBS) solution were obtained from in situ investigations with electrochemical quartz crystal microbalance (EQCM): from experiments performed at 15 and 60 mg l −1 Fn solution concentrations, the maximum adsorption was reached within 30 min, and Fn adsorption seemed to be partially reversible, as about 15% of the initially adsorbed protein were removed upon PBS rinsing. The remaining amount of adsorbed Fn was around 1000 ng cm −2 and was similar for both protein concentrations in solution. Moreover, differences in kinetics were observed between the two concentrations: the initial adsorption rate was much larger at 60 mg l −1 than at 15 mg l −1 . Ex situ X‐ray photoelectron spectroscopy (XPS) characterizations were used to examine the surface after adsorption under flow (EQCM measurements) or in static conditions: identification of the adsorbed protein and of the passivated TiO 2 layer on metallic Ti. With bulk Ti samples, an isotherm of adsorption of Fn in PBS was established on the basis of a selection of Fn solution concentrations and on the maximum time required to get a steady state, for a given concentration. The equivalent thicknesses of adsorbed Fn ( d Fn (XPS), model of a continuous layer adsorbed on the passivated Ti samples) were estimated by XPS. At saturation, a plateau is reached corresponding to an equivalent thickness of 5.5 nm for Fn solution concentrations larger than 50 mg l −1 . The d Fn (XPS) values of the experiments performed under flow are in satisfactory agreement with the values determined from static adsorption experiments. Copyright © 2010 John Wiley & Sons, Ltd.Keywords
This publication has 20 references indexed in Scilit:
- Fibronectin adsorption on gold, Ti-, and Ta-oxide investigated by QCM-D and RSA modellingJournal of Colloid and Interface Science, 2008
- Cleaning of albumin‐contaminated Ti and Cr surfaces: an XPS and QCM studySurface and Interface Analysis, 2008
- Dynamics of Fibronectin Adsorption on TiO2 SurfacesLangmuir, 2007
- Surface engineering strategies for control of protein and cell interactionsSurface Science, 2004
- Fibronectin at a glanceJournal of Cell Science, 2002
- Effect of surface roughness of the titanium alloy Ti–6Al–4V on human bone marrow cell response and on protein adsorptionBiomaterials, 2001
- Surface analysis of human plasma fibronectin adsorbed to commercially pure titanium materialsJournal of Biomedical Materials Research, 1998
- Physico-chemical properties of human plasma fibronectin binding to well characterized titanium dioxideColloids and Surfaces B: Biointerfaces, 1998
- The role of adsorbed proteins in animal cell adhesionColloids and Surfaces B: Biointerfaces, 1994
- A rapid and sensitive method for the quantitation of microgram quantities of protein utilizing the principle of protein-dye bindingAnalytical Biochemistry, 1976