Hardness of Duplex Treated Stainless Steel
- 1 January 2018
- book chapter
- Published by IGI Global Scientific Publishing
- p. 447-466
Abstract
This chapter describes how the aim of duplex surface engineering includes chronological application of two surface modification technologies for the production of a surface, with collective properties. Duplex treatment of nitriding and carbonitriding of austenitic stainless steel is of high technical importance owing to its capability to increase hardness, corrosion and wear resistance of treated surface. Duplex treatment has been utilized to enhance the surface mechanical properties of austenitic stainless steel (AISI 304). The microstructure of nitrided surface indicates the development of nitride phases, Fe4N, Fe2N, CrN, Cr2N and γN whereas, duplex treated films shows the formation of FeC, Fe3C, Fe7C3, Cr3C2, Cr7C3, along with nitride phases like Fe3N. Both nitrided and duplex treated samples show the formation of cauliflower like grains. Surface micro hardness of treated substrates has been dependent on the variation of crystallite size and increased by 1.26 times the hardness of nitrided sample and 4.60 times the hardness of the untreated substrates.Keywords
This publication has 52 references indexed in Scilit:
- Nanostructuring of zirconium by femtosecond laser irradiation in the ambient environment of air and ethanolOptik, 2017
- Femtosecond laser induced nanostructuring of zirconium in liquid confined environmentChinese Physics B, 2017
- Carbon and nitrogen effects on microstructure and kinetics associated with bainitic transformation in a low-alloyed steelJournal of Alloys and Compounds, 2016
- Effect of dry and wet ambient environment on the pulsed laser ablation of titaniumApplied Surface Science, 2013
- Effect of annealing on structural and optoelectronic properties of nanostructured ZnSe thin filmsJournal of Alloys and Compounds, 2011
- Effect of N2 to C2H2 ratio on r.f. plasma surface treatment of austenitic stainless steelSurface and Coatings Technology, 2004
- Gas discharge plasmas and their applicationsSpectrochimica Acta Part B: Atomic Spectroscopy, 2002
- Characterisation of duplex layer structures produced by simultaneous implantation of nitrogen and carbon into austenitic stainless steel X5CrNi189Surface and Coatings Technology, 2000
- A microstructural model for predicting hardness profiles of Fe-Cr alloys after nitridingPhilosophical Magazine A, 1999
- Plasma immersion ion implantation of stainless steel: austenitic stainless steel in comparison to austenitic-ferritic stainless steelSurface and Coatings Technology, 1996