High-Energy Density Miniature Thermoelectric Generator Using Catalytic Combustion
Authors:
- S. TanakaSTS. Tanaka
- S. TomonariSTS. Tomonari
- D. SatohDSD. Satoh
- M. EsashiMEM. Esashi
- 6 February 2006
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in Journal of Microelectromechanical Systems
- Vol. 15 (1) , 195-203
Abstract
This paper describes the components and system of a thermoelectric (TE) generator with a catalytic butane combustor. The combustion chamber with a size of 8 mm/spl times/8 mm/spl times/0.4 mm is etched in a 0.65-mm-thick silicon substrate, and bonded to both sides of a 0.77-mm-thick glass substrate with a thin-film ignition heater. A set of 34 couples of BiTe TE elements, each with a size of 0.65 mm/spl times/0.65 mm/spl times/2 mm, are directly bonded to both sides of the combustor. The combustor without the TE modules was tested using butane as fuel, and self-sustaining combustion and electrical ignition were achieved. Also, nearly 100% combustion efficiency and a uniform temperature distribution were confirmed by gas chromatography and infrared thermoimaging, respectively. When the TE modules were attached to the combustor, however, butane combustion was impossible. The characteristics of TE generation were measured using hydrogen as fuel. When a theoretical combustion power was 6.6 W, the maximum output power of 184 mW was obtained with a load of 5.68 /spl Omega/. The total efficiency in this experiment was 2.8% (184 mW/6.6 W).Keywords
This publication has 26 references indexed in Scilit:
- Fabrication of novel MEMS-based polymer electrolyte fuel cell architectures with catalytic electrodes supported on porous SiO2Journal of Micromechanics and Microengineering, 2006
- Turbo test rig with hydroinertia air bearings for a palmtop gas turbineJournal of Micromechanics and Microengineering, 2004
- Development of Micromachine Gas Turbine for Portable Power GenerationJSME International Journal Series B, 2004
- A microfabricated suspended-tube chemical reactor for thermally efficient fuel processingJournal of Microelectromechanical Systems, 2003
- Microfabricated fuel cellsElectrochimica Acta, 2003
- Development of an axial microturbine for a portable gas turbine generatorJournal of Micromechanics and Microengineering, 2003
- MEMS-Based Fuel Reformer with Suspended Membrane StructureIEEJ Transactions on Sensors and Micromachines, 2003
- Design considerations for miniaturized PEM fuel cellsJournal of Power Sources, 2002
- Miniature fuel cells fabricated on silicon substratesAIChE Journal, 2002
- Fuel cells for low power applicationsJournal of Power Sources, 2002