Abstract
The effect of unidirectional and cross rolling on the corrosion rate, texture, tensile properties and hemolysis of the Mg‐0.375Ga and Mg‐0.750Ga alloys was evaluated. Pure Mg and as‐cast alloys were processed by unidirectional and cross rolling at 400°C to obtain a total thickness reduction of 50%. The corrosion rate was measured by the weight loss method in simulated body fluid. Determination of the hemolysis percentage was carried out by direct contact of specimens with diluted blood. After hot rolling, the mechanical properties of the alloys were improved. The cross‐rolled Mg‐0.750Ga alloy showed the highest grain refinement (55 μm) and the highest ultimate tensile strength (240 MPa), however, lower elongation (13.9%) than the rolled Mg‐0.375Ga alloy. While unidirectional rolling creates a strong basal texture, cross rolling weakens considerably this texture. The Ga addition weakens the basal texture. Corrosion rate of the Mg‐Ga alloys was significantly reduced (22.7%) and as‐cast alloys (>24.2%); however, the alloys are still hemolytic (>5%).

This publication has 62 references indexed in Scilit: