A baseband processor for impulse ultra-wideband communications
Authors:
- P.P. NewaskarPNP.P. Newaskar
- F.S. LeeFLF.S. Lee
- A.P. ChandrakasanACA.P. Chandrakasan
- 29 August 2005
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Journal of Solid-State Circuits
- Vol. 40 (9) , 1821-1828
Abstract
This paper presents a baseband processor architecture for pulsed ultra-wideband signals. It consists of an analog-to-digital converter (ADC), a clock generation system, and a digital back-end. The clock generation system provides different phases of a 300-MHz clock using four differential inverter stages. The specification of the jitter standard deviation is 100 ps. The Flash interleaved ADC provides four bit samples at 1.2 Gsps. The back-end uses parallelization to process these samples and to reduce the signal acquisition time to 65 /spl mu/s. The entire synchronization algorithm is implemented in the digital domain, without feeding any signals back to the clock control. The baseband processor and ADC were implemented on the same 0.18-/spl mu/m CMOS die at 1.8 V as part of a complete baseband transceiver. A wireless data rate of 193 kb/s is demonstrated.Keywords
This publication has 8 references indexed in Scilit:
- An ultra-wideband baseband front-end2004
- A/D precision requirements for an ultra-wideband radio receiver2003
- Ultra-wide band radio: the emergence of an important new technology2002
- All-digital PAM impulse radio for multiple-access through frequency-selective multipath2002
- All-digital PPM impulse radio for multiple-access through frequency-selective multipath2002
- Design of High-Performance Microprocessor Circuits2000
- Low-jitter process-independent DLL and PLL based on self-biased techniquesIEEE Journal of Solid-State Circuits, 1996
- Full-speed testing of A/D convertersIEEE Journal of Solid-State Circuits, 1984