Surface Quality Evaluation of 3D-Printed Carbon-Fiber-Reinforced PETG Polymer During Turning: Experimental Analysis, ANN Modeling and Optimization
Open Access
Abstract
This work presents an experimental analysis related to 3D-printed carbon-fiber-reinforced-polymer (CFRP) machining. A polyethylene-terephthalate-glycol (PETG)-based composite, reinforced with 20% carbon fibers, was selected as the test material. The aim of the study was to evaluate the influence of cutting conditions used in light operations on the generated surface quality of the 3D-printed specimens. For this purpose, nine specimens were fabricated and machined under a wide range of cutting parameters, including cutting speed, feed, and depth of cut. The generated surface roughness was measured with a mechanical gauge and the acquired data were used to develop a shallow artificial neural network (ANN) for prediction purposes, showing that a 3-6-1 structure is the best solution. Following this, a genetic algorithm (GA) was utilized to minimize the response, revealing that the optimal combination is 205 m/min speed, 0.0578 mm/rev feed, and 0.523 mm depth of cut, contributing to the fabrication of low friction parts and shafts with a high quality surface, as well as to the reduction of resource waste. A validation study supported the accuracy of the developed model, by exhibiting errors below 10%. Finally, a set of enhanced images were taken to assess the machined surfaces. It was found that 1.50 mm depth of cut is responsible for the generation of defects across the circumference of the specimens. Especially, combined with 150 m/min cutting speed and 0.11 mm/rev feed, more flaws are produced.Keywords
This publication has 56 references indexed in Scilit:
- Drilling performance prediction of HDPE/Washingtonia fiber biocomposite using RSM, ANN, and GA optimizationThe International Journal of Advanced Manufacturing Technology, 2022
- 3D Printing of Acrylonitrile Butadiene Styrene by Fused Deposition Modeling: Artificial Neural Network and Response Surface Method AnalysesJournal of Materials Engineering and Performance, 2022
- Optimization of cutting parameters for improving exit delamination, surface roughness, and production rate in drilling of CFRP compositesThe International Journal of Advanced Manufacturing Technology, 2021
- Prediction modeling of surface roughness in milling of carbon fiber reinforced polymers (CFRP)The International Journal of Advanced Manufacturing Technology, 2021
- Effect of Tool Vibration on Flank Wear and Surface Roughness During High-Speed Machining of 1040 SteelJournal of Failure Analysis and Prevention, 2020
- Environmentally conscious machining of Inconel 718: surface roughness, tool wear, and material removal rate assessmentThe International Journal of Advanced Manufacturing Technology, 2019
- Prediction and optimization by using SVR, RSM and GA in hard turning of tempered AISI 1060 steel under effective cooling conditionNeural Computing and Applications, 2017
- Machinability investigation in hard turning of AISI D3 cold work steel with ceramic tool using response surface methodologyThe International Journal of Advanced Manufacturing Technology, 2014
- Prediction of Damage Factor in end Milling of Glass Fibre Reinforced Plastic Composites Using Artificial Neural NetworkApplied Composite Materials, 2012
- GA Approach for Optimization of Surface Roughness Parameters in Machining of Al Alloy SiC Particle CompositeJournal of Materials Engineering and Performance, 2011