Effect of Surface Treatment With Er:YAG and CO2 Lasers on Shear Bond Strength of Polyether Ether Ketone to Composite Resin Veneers
Open Access
- 15 March 2020
- journal article
- research article
- Published by Maad Rayan Publishing Company in Journal of lasers in medical sciences
- Vol. 11 (2) , 153-159
Abstract
Introduction: Polyether ether ketone (PEEK) has low surface energy and high resistance to chemical surface treatments. Therefore, different surface treatments such as laser conditioning should be investigated. There is a gap of information regarding the efficacy of laser irradiation in the surface treatment of PEEK, and the efficacy of several laser types needs to be evaluated for this purpose. This study aimed to assess the effect of surface treatment with erbium-doped yttrium aluminum garnet (Er:YAG) and carbon dioxide (CO2) lasers on shear bond strength (SBS) of PEEK to composite resin veneers. Methods: In this experimental study, 60 rectangular-shaped PEEK samples (7 x 7 x 2 mm) were used. The samples were mounted in auto-polymerizing acrylic resin in such a way that only one surface measuring 7x7 mm remained exposed. The samples were then randomly divided into 3 groups (n=20) of control, Er:YAG laser surface treatment (Power=1.5 W, energy density=119.42 J/cm2 , irradiation time=20 s) and CO2 laser surface treatment (Power=4 W, energy density=159.22 J/cm2 , irradiation time=50 s). The bonding agent and PEEK opaque were applied on the surface of samples and they were veneered with a composite resin using a hollow plastic cylinder with an internal diameter of 4 mm. The SBS was then measured and the data were analyzed using one-way ANOVA, Tukey HSD test and Dunnett’s test at 0.05 level of significance. Results: The SBS of the 3 groups was significantly different (PConclusion: The Er:YAG and CO2 laser treatments can increase the SBS of PEEK to composite resin veneers, although the Er:YAG laser seems to be more effective for this purpose.Keywords
This publication has 54 references indexed in Scilit:
- Polyetheretherketone-A suitable material for fixed dental prostheses?Journal of Biomedical Materials Research Part B: Applied Biomaterials, 2013
- SEM evaluation of surface morphologic analysis of restorative materials with three laser treatmentJournal of Dental Lasers, 2013
- Shear Bond Strength of Resin Cement to Zirconia Ceramic After Aluminum Oxide Sandblasting and Various Laser TreatmentsPhotomedicine and Laser Surgery, 2011
- Evaluation of the topographical surface changes and roughness of zirconia after different surface treatmentsLasers in Medical Science, 2011
- Improvement of flame spraying PEEK coating characteristics using lasersJournal of Materials Processing Technology, 2011
- Effect of Erbium-Doped Yttrium Aluminium Garnet Laser Parameters on Ablation Capacity and Morphology of Primary DentinPhotomedicine and Laser Surgery, 2009
- Effect of acid etching duration on tensile bond strength of composite resin bonded to erbium:yttrium–aluminium–garnet laser-prepared dentine. Preliminary studyLasers in Medical Science, 2009
- Evaluation of the Surface Roughness and Morphologic Features of Y-TZP Ceramics after Different Surface TreatmentsPhotomedicine and Laser Surgery, 2009
- Microleakage and scanning electron microscopy evaluation of all-in-one self-etch adhesives and their respective nanocomposites prepared by erbium:yttrium–aluminum–garnet laser and burLasers in Medical Science, 2009
- Measurement methods for adhesion to dentine: the current status in JapanJournal of Dentistry, 1994