Subsoil properties and cereal growth as affected by a single pass of heavy machinery and two tillage systems on a Luvisol
- 6 August 2008
- journal article
- research article
- Published by Wiley in Journal of Plant Nutrition and Soil Science
- Vol. 171 (4) , 580-590
Abstract
Compared to moldboard plowing, conservation tillage is frequently discussed to alleviate soil stresses caused by high wheel loads and, thus, decrease the risk of subsoil compaction. On a Luvisol derived from loess (Göttingen, Lower Saxony, Germany), a wheeling experiment was conducted in two contrasting tillage systems (continuous moldboard plowing [MP] 30 cm deep and shallow mixing [SM] 10 cm deep). A six‐row self‐propelled sugar beet tanker harvester (SBH 6: 34–36 Mg total vehicle weight, 8–11 Mg wheel load, 92–143 kPa calculated ground‐contact pressure) was used for a single pass. Each crop of the sugar beet–cereal–cereal rotation was cultivated with light experimental machinery on one of three adjacent fields each year. In October 2001 (Field 2), 2002 (Field 1), and 2003 (Field 3) wheeling with the SBH 6 was carried out on half of every tillage plot (soil moisture 70%–100% field capacity) after the harvest of previous sugar beet. Subsequently, the soil was tilled according to the respective treatment, and winter wheat, spring wheat, and spring barley were grown on Field 2, 1, and 3, respectively. During the following spring and summer, soil and plant measurements were conducted. Soil penetration resistance (10–25 cm) increased, and root length density of spring wheat decreased in SM tillage compared to MP tillage. At 40–45 cm depth, air‐filled pore volume at 6.2 kPa water tension (two fields), air permeability, and total pore volume (one field) were higher in SM than in MP treatments, respectively. Wheeling slightly increased penetration resistance in 15–25 cm depth but had no effect on any parameter measured at 40–45 cm soil depth. Generally, treatment effects on cereal‐grain yield were small and insignificant. Our results suggest that a single pass with a SBH 6 is unlikely to cause pronounced subsoil‐structure degradation on a loessial soil under moderate climatic conditions.Keywords
This publication has 34 references indexed in Scilit:
- Ist der Konzentrationsfaktor k eines aggregierten Bodens als steuernde Größe der mechanischen Druckverteilung in Böden eine Konstante?Journal of Plant Nutrition and Soil Science, 2004
- Effects of agricultural machinery with high axle load on soil properties of normally managed fieldsSoil and Tillage Research, 2004
- Vulnerability of subsoils in Europe to compaction: a preliminary analysisSoil and Tillage Research, 2003
- Influence of single passes with high wheel load on a structured, unploughed sandy loam soilSoil and Tillage Research, 1999
- Ploughing effects on soil organic matter after twenty years of conservation tillage in Lower Saxony, GermanySoil and Tillage Research, 1999
- Indirect Determination of Leaf Area Index of Sugar Beet Canopies in Comparison to Direct MeasurementJournal of Agronomy and Crop Science, 1995
- Subsoil compaction by vehicles with high axle load—extent, persistence and crop responseSoil and Tillage Research, 1994
- Penetration resistance and root growth of oats in tilled and untilled loess soilSoil and Tillage Research, 1983
- Tillage effects on root development, water uptake and growth of oatsSoil and Tillage Research, 1980
- Vereinfachte Methodik und Auswertung der Permeabilitätsmessung des Bodens für LuftJournal of Plant Nutrition and Soil Science, 1965