A Novel Vertical Conductive Structure for Printed Circuit Boards and its Scalable Model
- 19 April 2024
- journal article
- research article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Signal and Power Integrity
- Vol. 3, 67-74
Abstract
This article proposes a new vertical conductive structure (VeCS) to replace the general via structure for signal connection on printed circuit boards (PCBs). Vias have been widely used as interconnects for in-between layers in PCBs. However, vias have limitations due to their discontinuous characteristic impedance. The VeCS consists of a conductive structure shielded vertically by a metal structure, which provides impedance control. Thus, the VeCS has the constant characteristic impedance that can get better signal integrity for the high-speed channel than the general via structure. This article also proposes a scalable 3-D electromagnetic simulation model of the VeCS for signal integrity analysis. Simulated annealing and linear regression revealed that the scalable model accurately represents the VeCS. The electrical performances of a VeCS and a via were compared up to 70 GHz. The measured insertion losses at 70 GHz for the VeCS and the via were 35 dB and 70 dB, respectively, because PCB vias exhibit significant reflection loss above 10 GHz. In conclusion, this article proposes a novel vertical interconnection for PCBs.Keywords
Funding Information
- National Science Foundation (IIP-1916535)
This publication has 22 references indexed in Scilit:
- High-Speed Differential Via Optimization using a High-Accuracy and High-Bandwidth Via Model2023
- Mode-decomposition-based Equivalent Via (MEV) Model and MEV Model Application Range Analysis2023
- Modeling Reflections in a Complex Cable Structure with Impedance Mismatches2021
- High-Density Through Silicon Vias for 3-D LSIsProceedings of the IEEE, 2009
- Through-Silicon Via (TSV)Proceedings of the IEEE, 2009
- Demystifying 3D ICs: The Pros and Cons of Going VerticalIEEE Design & Test of Computers, 2005
- Understanding the importance of signal integrityIEEE Circuits and Devices Magazine, 1999
- Full-wave characterization of a through hole via in multi-layered packagingIEEE Transactions on Microwave Theory and Techniques, 1995
- Scalar magnetostatic potential approach to the prediction of the excess inductance of grounded via's and via's through a hole in a ground planeIEEE Transactions on Microwave Theory and Techniques, 1994
- Quasi-static analysis of a microstrip via through a hole in a ground planeIEEE Transactions on Microwave Theory and Techniques, 1988