COMPARISON BETWEEN THE TWO- AND THREE-PHASE MODELS FOR ANALYSIS OF POROSITY FORMATION IN ALUMINUM-RICH CASTINGS
Authors:
- 1 June 1996
- journal article
- research article
- Published by Taylor & Francis in Numerical Heat Transfer, Part A: Applications
- Vol. 29 (8) , 859-867
Abstract
This article presents comparisons between an analytical and a numerical investigation of porosity formation within the mushy zone during the solidification process. For this purpose, a three-phase model (liquid, solid, and gas) of the mushy zone is utilized. This model takes into account the release of the dissolved gas from the alloy as well as the heat transfer and interdendritic fluid flow in the two-phase region. The main difference between the three-phase model and the two-phase model (only liquid and solid), which is usually used to predict the porosity distribution, is the inclusion of a term describing the porosity formation in Ike continuity equation. The perturbation method is used to obtain an analytical solution describing the porosity formation. Pressure and porosity distributions predicted by these two models are compared for the particular case of aluminum-rich Al-Cu castings.Keywords
This publication has 3 references indexed in Scilit:
- Development and investigation of three-phase model of the mushy zone for analysis of porosity formation in solidifying castingsInternational Journal of Heat and Mass Transfer, 1995
- Modeling of equiaxed microstructure formation in castingMetallurgical Transactions A, 1989
- Mathematical modeling of porosity formation in solidificationMetallurgical Transactions B, 1985