Impact of droplet oxidation on mechanical properties of an Al-7Si-0.4Mg alloy fabricated with liquid metal jetting
Authors:
- Sumit BahlSBSumit Bahl
- Gerry L. KnappGKGerry L. Knapp
- Alexander GomezAGAlexander Gomez
- Jonathan D. PoplawskyJPJonathan D. Poplawsky
- James A. HaynesJHJames A. Haynes
- Ryan R. DehoffRDRyan R. Dehoff
- Alex PlotkowskiAPAlex Plotkowski
- Amit ShyamASAmit Shyam
- 4 April 2025
- journal article
- Published by Elsevier in Additive Manufacturing
- Vol. 103
Abstract
No abstract availableFunding Information
- U.S. Department of Energy
- Office of Science
- Office of Energy Efficiency and Renewable Energy
- Oak Ridge National Laboratory
This publication has 33 references indexed in Scilit:
- An additively manufactured near-eutectic Al-Ce-Ni-Mn-Zr alloy with high creep resistanceActa Materialia, 2024
- Metal Droplet Deposition: From Foundation to Engineering ManufacturingAdvanced Engineering Materials, 2022
- Cavitation-resistant intergranular precipitates enhance creep performance of θ′-strengthened Al-Cu based alloysActa Materialia, 2022
- Comparative Evaluation of Cast Aluminum Alloys for Automotive Cylinder Heads: Part I—Microstructure EvolutionMetallurgical and Materials Transactions A, 2017
- 3D numerical simulation of successive deposition of uniform molten Al droplets on a moving substrate and experimental validationComputational Materials Science, 2012
- Solute nanostructures and their strengthening effects in Al–7Si–0.6Mg alloy F357Acta Materialia, 2012
- The crystal structure of the β′ phase in Al–Mg–Si alloysActa Materialia, 2007
- Microstructure-based fatigue life prediction for cast A356-T6 aluminum-silicon alloysMetallurgical and Materials Transactions B, 2006
- Eutectic nucleation in Al–Si alloysActa Materialia, 2004
- Grain boundary ductile fracture in precipitation hardened aluminum alloysActa Metallurgica, 1987