Drying temperature effects on bulk density and carbon density determination in soils of northern New South Wales
- 11 December 2009
- journal article
- research article
- Published by CSIRO Publishing in Soil Research
- Vol. 47 (8) , 781-787
Abstract
There is a widespread and growing need for information relating to soil condition and changes in response to land management pressures. To provide the information needed to quantify land management effects on soil condition, monitoring systems are now being put in place and these programs will generate large numbers of samples. Streamlined procedures for the analysis of large sample numbers are therefore required. Bulk density (BD) is considered to be one of several key indicators for measuring soil physical condition, and is also required to estimate soil carbon density. The standard analytical technique for BD requires drying the soil at 105°C but this procedure creates several logistical and analytical problems. Our initial objective was to derive correction factors between drying temperatures to allow for rapid, low-temperature estimation of BD on large sample numbers. Soil samples were collected from 3 contrasting soil types (basalt, granite, and meta-sediments) in 4 land uses (cultivation, sown pasture, native pasture, woodland) in northern New South Wales to test the effect of soil drying temperature on BD determination. Cores were divided into 4 depths (0–0.05, 0.050–0.10, 0.10–0.20, 0.20–0.30 m), and oven-dried at 40, 70, and 105°C. Drying temperature had no significant effect on BD but the effects of soil type, depth, and land use were significant, varying according to expectations based on previous studies, i.e. higher BD in granite-derived soils and lower in basalt-derived soils, increased BD with depth, and increasing BD with increasing management intensity. These results indicate that lower drying temperatures (40°C) were adequate for the efficient determination of BD especially where analysis of other soil properties from the same sample is required. However, before this approach is applied more widely, further calibration of BD and drying temperature should be undertaken across a wider range of soils, especially on clay-rich soils.Keywords
This publication has 8 references indexed in Scilit:
- Land-use effects on soil properties on the north-western slopes of New South Wales: Implications for soil condition assessmentSoil Research, 2008
- Building and testing conceptual and empirical models for predicting soil bulk densitySoil Use and Management, 2007
- Soil bulk density evaluation by conventional and nuclear methodsSoil Research, 2005
- Carbon storage in the soils and vegetation of contrasting land uses in northern New South Wales, AustraliaSoil Research, 2005
- Soil and catchment health indicators of sustainability: case studies from southern Australia and possibilities for the northern grains region of AustraliaAustralian Journal of Experimental Agriculture, 2003
- Application of sustainability indicators, soil organic matter and electrical conductivity, to resource management in the northern grains regionAustralian Journal of Experimental Agriculture, 2003
- A pedo-transfer function (PTF) for estimating soil bulk density from basic soil data and its comparison with existing PTFsSoil Research, 2002
- Soil Quality: A Concept, Definition, and Framework for Evaluation (A Guest Editorial)Soil Science Society of America Journal, 1997