Technical aspects of separation using aqueous two‐phase systems in enzyme isolation processes
Authors:
- 1 December 1978
- journal article
- research article
- Published by Wiley in Biotechnology and Bioengineering
- Vol. 20 (12) , 1967-1988
Abstract
Technical aspects of the separation of aqueous two‐phase systems in a commercial separator were studied in detail. For the Gyrotester B, the smallest available separator, a flow rate of 200 ml/min and a length of the regulating screw in the outlet port of 13.5 mm were found as optimal operation parameters for the separation of a poly(ethylene glycol) (PEG)/dextran two‐phase system. In the presence of cells and cell debris the characteristics of the carrier two‐phase systems are changed, most notably the phase ratio. Nevertheless good separation and high throughput can be maintained up to 30% wet cell material in the complete system. Using this method the enzyme pullulanase was extracted from 6.65 kg Klebsiella pneumoniae in 88% yield in a single step in less than 2 hr. A yield of 90% was predicted for this step based upon laboratory data, indicating that the performance of the extraction and separation can be calculated with the necessary accuracy and the further scale‐up of the process should be accomplished quite easily. The hydrophilic polymers Constituting the phase system will often stabilize the enzymes, So that the separation can be carried out at room temperature without extensive cooling. The method of enzyme solubilization or cell disruption is not decisive for the successful extraction of the enzymes, the only limitation being the necessity to find a suitable two‐phase system where the desired product and the cells or cell debris will partition in opposite phases. This is shown for α‐glucosidase from Saccharomyces carlsbergensis and three aminoacyl‐tRNA‐synthetases from Escherichia coli. The results obtained demonstrate that aqueous two‐phase systems can be separated in commercially available separators with high capacity and efficiency. It can be expected that the advanced separation technology available from chemical engineering studies can also be used for the development of large‐scale isolation processes for enzymes involving liquid–liquid partitions.Keywords
This publication has 13 references indexed in Scilit:
- Studies of the Interaction between Aminoacyl‐tRNA Synthetase and Transfer Ribonucleic Acid by Equilibrium PartitionEuropean Journal of Biochemistry, 1977
- Selectivity of protein precipitation with polyethylene glycol fractions of various molecular weightsAnalytical Biochemistry, 1976
- Pullulanase is a characteristic of manyKlebsiella species and functions in the degradation of starchApplied Microbiology and Biotechnology, 1976
- Diffusion of proteins across a liquid-liquid interfaceBiochimica et Biophysica Acta (BBA) - General Subjects, 1973
- Isolation and Properties of Isoleucyl‐tRNA Synthetase from Escherichia coli MRE 600European Journal of Biochemistry, 1973
- Pullulanase von Aerobacter aerogenesArchives of Microbiology, 1970
- Pullulanase from aerobacter aerogenes; production in a cell-bound state. Purification and properties of the enzymeBiochemical and Biophysical Research Communications, 1966
- Pullulan, ein extracelluläres Glucan von Pullularia pullulansBiochimica et Biophysica Acta, 1959
- The purification and properties of an α-glucoside of Saccharomyces italicus Y1225Biochimica et Biophysica Acta, 1958
- A PHOTOMETRIC ADAPTATION OF THE SOMOGYI METHOD FOR THE DETERMINATION OF GLUCOSEJournal of Biological Chemistry, 1944