Improving Robotic Milling Performance through Active Damping of Low-Frequency Structural Modes
Open Access
- 27 July 2024
- journal article
- research article
- Published by MDPI AG in Journal of Manufacturing and Materials Processing
- Vol. 8 (4) , 160
Abstract
Industrial robots are increasingly prevalent due to their large workspace and cost-effectiveness. However, their limited static and dynamic stiffness can lead to issues like mode coupling chatter and regenerative chatter in robotic milling processes, even at shallow cutting depths. These problems significantly impact performance, product quality, tool longevity, and can damage robot components. An active inertial actuator was deployed at the milling spindle to enhance dynamic stiffness and suppress low-frequency vibrations effectively. It was identified that the characteristics of the actuator change with its mounting orientation, a common scenario in robotic machining processes. This variation has not been reported in the literature. Our study includes the identification of model parameters for the actuator in both horizontal and vertical mountings. Additionally, the novelty of the present work lies in the specific design and implementation of compensation filters tailored for the active inertial actuator in both horizontal and vertical configurations. These filters address the unique challenges posed by low-frequency vibrations in robotic milling, offering significant improvements in dynamic stiffness and vibration suppression. Traditional model-based compensators were effective for vertical mounting, while pole-zero placement techniques with minimum phase systems were optimal for horizontal mounting. These compensators significantly enhanced dynamic stiffness, reducing maximum low-frequency robot structural modes by approximately 100% in horizontal mounting and approximately 214% in the vertical configuration of the actuator. This advancement promises to enhance industrial robot capabilities across diverse machining applications.Keywords
Funding Information
- IGSTC Post-Doctoral Industrial Fellowship (PDIF)—2021
This publication has 36 references indexed in Scilit:
- Vibration-Damped Tool Holders in Industrial Robotic Machining SystemsInternational Journal of Precision Engineering and Manufacturing, 2023
- Chip wave phase difference analysis of robotic milling and chatter dominant mode researchThe International Journal of Advanced Manufacturing Technology, 2022
- Adaptive Model-Free Gain Tuning for Active Damping of Machine Tool VibrationsJournal of Vibration Engineering & Technologies, 2022
- Edge finishing of large turbine casings using defined multi-edge and abrasive tools in automated cellsThe International Journal of Advanced Manufacturing Technology, 2021
- Validation of a hardware-in-the-loop simulator for investigating and actively damping regenerative chatter in orthogonal cuttingCIRP Journal of Manufacturing Science and Technology, 2020
- Mode coupling chatter prediction and avoidance in robotic machining processThe International Journal of Advanced Manufacturing Technology, 2019
- Robots in machiningCIRP Annals, 2019
- Simulation and development of an active damper with robust μ-control for a machine tool with a gantry portalProduction Engineering, 2016
- Coupled model for simulating active inertial actuators in milling processesThe International Journal of Advanced Manufacturing Technology, 2014
- Vibration Control of Active Structures2011