Full Vehicle Vibration and Noise Analysis Based on Substructure Power Flow
Open Access
- 30 April 2017
- journal article
- research article
- Published by Wiley in Shock and Vibration
- Vol. 2017, 1-17
Abstract
Combining substructure and power flow theory, in this paper an external program is written to control MSC. Nastran solution process and the substructure frequency response are also formulated accordingly. Based on a simple vehicle model, characteristics of vibration, noise, and power flow are studied, respectively. After being compared with the result of conventional FEM (finite element method), the new method is confirmed to be feasible. When it comes to a vehicle with the problem of low-frequency noise, finite element models of substructures for vehicle body and chassis are established, respectively. In addition, substructure power flow method is also employed to examine the transfer characteristics of multidimensional vibration energy for the whole vehicle system. By virtue of the adjustment stiffness of drive shaft support and bushes at rear suspension lower arm, the vehicle interior noise is decreased by about 3 dB when the engine speed is near 1050 rpm and 1650 rpm in experiment. At the same time, this method can increase the computation efficiency by 78%, 38%, and 98% when it comes to the optimization of chassis structure, body structure, and vibration isolation components, respectively.Keywords
Funding Information
- National Natural Science Foundation of China (51575410)
This publication has 12 references indexed in Scilit:
- Vibration Transfer Path Analysis and Path Ranking for NVH Optimization of a Vehicle InteriorShock and Vibration, 2014
- A vibro-acoustic reduced order model using undeformed coupling interface substructuring – Application to rubber bushing isolation in vehicle suspension systemsApplied Acoustics, 2014
- Prediction of NVH behaviour of trimmed body components in the frequency range 100–500HzApplied Acoustics, 2010
- Combination of an Improved FRF‐Based Substructure Synthesis and Power Flow Method with Application to Vehicle Axle Noise AnalysisShock and Vibration, 2006
- Guidelines for the implementation of the CWELD and ACM2 spot weld models in structural dynamicsFinite Elements in Analysis and Design, 2004
- A New Method for Analysis of Complex Structures Based on FRF’s of SubstructuresShock and Vibration, 2003
- POWER FLOW ANALYSIS OF COMPLEX COUPLED SYSTEMS BY PROGRESSIVE APPROACHESJournal of Sound and Vibration, 2001
- Application of Vibrational Power Flow to a Passenger Car for Reduction of Interior NoiseShock and Vibration, 2000
- Power Flow Finite Element Analysis of Dynamic Systems: Basic Theory and Application to BeamsJournal of Vibration and Acoustics, 1989
- Vibrational power flow from machines into built-up structures, part I: Introduction and approximate analyses of beam and plate-like foundationsJournal of Sound and Vibration, 1980