Predictable Three-Dimensional Microfluidic Channel Fabrication in a Single-Mask Process
- 1 January 2007
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 755-758
Abstract
This paper presents the results of an investigation into the effect of geometrical patterns of the photomask on the dimensions of the trench that evolves after silicon isotropic etching. The study is based on the most complex surface pattern to date, composed of five independent geometric variables. Data from over 180 different patterns was collected to examine the influence of each parameter on the result. Two Langmuir-based models were developed relating the channel depth and width dimensions to the exposed pattern. These new models provide the capability to design complex microfluidic networks using only a single mask with channel dimensions predicted to 5% of their actual value.Keywords
This publication has 6 references indexed in Scilit:
- Microfabrication of 3D silicon MEMS structures using gray-scale lithography and deep reactive ion etchingSensors and Actuators A: Physical, 2005
- Single-mask, three-dimensional microfabrication of high-aspect-ratio structures in bulk silicon using reactive ion etching lag and sacrificial oxidationApplied Physics Letters, 2004
- The MEMSNAS Process: Microloading Effect for Micromachining 3-D Structures of Nearly All ShapesJournal of Microelectromechanical Systems, 2004
- Fabrication of out-of-plane curved surfaces in Si by utilizing RIE lag2003
- Etching High Aspect Ratio Silicon TrenchesJournal of the Electrochemical Society, 2003
- Microloading effect in reactive ion etchingJournal of Vacuum Science & Technology A, 1994