Non-axisymmetric Homann stagnation-point flows
Author:
- 18 May 2012
- journal article
- research article
- Published by Cambridge University Press (CUP) in Journal of Fluid Mechanics
- Vol. 702, 460-469
Abstract
A modification of Homann’s axisymmetric outer potential stagnation-point flow of strain rate $a$ is obtained by adding periodic radial and azimuthal velocities of the form $b\hspace{0.167em} r\sin 2\theta $ and $b\hspace{0.167em} r\cos 2\theta $ , respectively, where $b$ is a shear rate. This leads to the discovery of a new family of asymmetric viscous stagnation-point flows depending on the shear-to-strain-rate ratio $\gamma = b/ a$ that exist over the range $\ensuremath{-} \infty \lt \gamma \lt \infty $ . Numerical solutions for the wall shear stress parameters and the displacement thicknesses are given and compared with their large- $\gamma $ asymptotic behaviours. Sample similarity velocity profiles are also presented.
Keywords
This publication has 10 references indexed in Scilit:
- Continua of states in boundary-layer flowsJournal of Fluid Mechanics, 2002
- Steady boundary-layer solutions for a swirling stratified fluid in a rotating coneJournal of Fluid Mechanics, 1999
- Dual solutions of the boundary-layer equations at a point of attachmentJournal of Fluid Mechanics, 1967
- Three-dimensional flow near a two-dimensional stagnation pointJournal of Fluid Mechanics, 1967
- Heat and mass transfer at a general three- dimensional stagnation point.AIAA Journal, 1967
- ROTATIONAL FLOW NEAR A FORWARD STAGNATION POINTQuarterly Journal of Mechanics and Applied Mathematics, 1963
- Boundary-layer flow at a saddle point of attachmentJournal of Fluid Mechanics, 1961
- On displacement thicknessJournal of Fluid Mechanics, 1958
- CXLIV. The boundary layer in three dimensional flow.—Part II. The flow near a stagnation pointJournal of Computers in Education, 1951
- Der Einfluß großer Zähigkeit bei der Strömung um den Zylinder und um die KugelZAMM - Journal of Applied Mathematics and Mechanics / Zeitschrift für Angewandte Mathematik und Mechanik, 1936