Evaluation of the Mechanical Properties of Polypropylene-Aluminum-Dross Composite
Open Access
- 15 March 2012
- journal article
- Published by Wiley in ISRN Polymer Science
- Vol. 2012, 1-6
Abstract
Aluminum (Al) dross is a hazardous waste from the secondary smelting of aluminium industries, and safe disposal of this waste is a big challenge to these industries. Dumping of this waste is an environmental hazard to plants, animals, and even human beings. This study is aimed at improving the mechanical properties of polypropylene (PP) by adding Al dross in 2–50 wt% for particle sizes 53 μm and 150 μm. PP-Al-dross composite samples were cast, and ultimate tensile strength (UTS), impact resistance (IR), water absorption (WA), and density (D) tests were carried out. The results obtained show that UTS improved by 68% (at 15 wt% Al-dross addition), D increased by 54% (at 50 wt% Al-dross addition), and WA by 500% (at 8 wt% Al-dross addition) over the convectional PP. The impact resistance of the composite was found to be the same (68 J) with that of conventional PP at 15 wt% Al dross.Keywords
This publication has 22 references indexed in Scilit:
- Synthesis of AlPO4-5 and CrAPO-5 using aluminum drossJournal of Hazardous Materials, 2009
- The reuse of nonmetals recycled from waste printed circuit boards as reinforcing fillers in the polypropylene compositesJournal of Hazardous Materials, 2009
- Production of η-alumina from waste aluminium drossMinerals Engineering, 2007
- Mechanical properties and morphologies of polypropylene/single‐filler or hybrid‐filler calcium carbonate compositesPolymer Engineering & Science, 2007
- Effect of inclusion size on mechanical properties of polymeric composites with micro and nano particlesComposites Science and Technology, 2006
- Comparison of the mechanical properties and interfacial interactions between talc, kaolin, and calcium carbonate filled polypropylene compositesJournal of Applied Polymer Science, 2004
- Toughening and reinforcing in rigid inorganic particulate filled poly(propylene): A reviewJournal of Applied Polymer Science, 2001
- Recycling of municipal solid waste for cement production: pilot-scale test for transforming incineration ash of solid waste into cement clinkerResources, Conservation and Recycling, 2001
- The quality of aluminum dross particles and cost-effective reinforcement for structural aluminum-based compositesComposites Science and Technology, 1999
- Selective crosslinking reaction in polymer blends. III. The effects of the crosslinking of dispersed EPDM particles on the impact behavior of PP/EPDM blendsJournal of Applied Polymer Science, 1995