The effects of cutting conditions on mixed ceramic and cubic boron nitride tool wear and on surface roughness during machining of X200Cr12 steel (60 HRC)
Authors:
- 1 January 2005
- journal article
- research article
- Published by SAGE Publications in Proceedings of the Institution of Mechanical Engineers, Part B: Journal of Engineering Manufacture
- Vol. 219 (1) , 35-55
Abstract
Alumina-based mixed ceramic (CC650) and cubic boron nitride-based (CBN) (CBN7020) tools are becoming mostly preferred for machining under severe conditions. The aim of this study is to investigate the effect of cutting parameters on ceramic and CBN tool wear in the hard turning of X200Cr12 steel. The results indicate that the comparison span for both tool materials is limited to a speed of 180 m/min at which catastrophic ceramic cutting edge collapse took place. The tool life ratio rose from 4.37 to 17.14 when the cutting speed evolved from 90 to 180 m/min in favour of CBN, which resisted up to a cutting speed of 350 m/min. The feed rate effect on roughness (μm) is satisfactorily predicted by a power model deduced from experimental data and is compared with a theoretical model. A correlation between surface roughness and tool wear is proposed for the usual cutting speed ranges and for the two tested inserts respectively. The analysis also revealed that, under the allowable wear limit, the ceramic tool gave quality surfaces with higher roughness than the CBN tool. In conclusion, this work highlights the fact that 120 m/min is the optimal cutting speed value for machining X200Cr12 steel using CBN7020 while 60 m/min is the optimal cutting speed value for CC650 steel.Keywords
This publication has 20 references indexed in Scilit:
- Hard turning of M50 steel with different microstructures in continuous and intermittent cuttingWear, 2003
- Machining of high chromium hardfacing materialsJournal of Materials Processing Technology, 2001
- Wear mechanisms of ultra-hard cutting tools materialsJournal of Materials Processing Technology, 2001
- Trends and recent developments in the material manufacture and cutting tool application of polycrystalline diamond and polycrystalline cubic boron nitrideInternational Journal of Refractory Metals and Hard Materials, 2000
- Machinability study of carbon fiber reinforced compositeJournal of Materials Processing Technology, 1999
- Wear characteristics in turning high hardness alloy steel by ceramic and CBN toolsJournal of Materials Processing Technology, 1999
- Cutting temperature: prediction and measurement methods—a reviewJournal of Materials Processing Technology, 1999
- Tool wear mechanism in continuous cutting of hardened tool steelsWear, 1997
- Investigations of the wear of cubic boron nitride cutting tools using Auger electron spectroscopy and X-ray analysis by EPMAWear, 1997
- Wear mechanisms of ceramic cutting tools when machining ferrous and non-ferrous alloysJournal of the European Ceramic Society, 1990