Numerical simulation of the sequential coinjection molding process based on level set method
- 17 September 2014
- journal article
- research article
- Published by Wiley in Polymer Engineering & Science
- Vol. 55 (8) , 1707-1719
Abstract
The sequential coinjection molding (SCIM) process has always been regarded as a challenging multiphase flow problem, which includes skin and core polymer melts together with gas. Thus, this article presents a 3D mathematical model for it, in which the governing equations of gas, skin, and core melts are united into a system namely the generalized Navier‐Stokes equations. By doing this, the model can be solved simply by applying the finite volume SIMPLE method on the collocated grid. The core penetration process is simulated by level set method, which can capture two different types of moving interface simultaneously at different time. By simulating the SCIM process of a centrally gated rectangular plate and then comparing the numerical results with available experiment results, the proposed mathematical model is validated and the influences of skin/core volume ratio, injection temperature, and core injection delay on the depth of core penetration are analyzed in detail. Then, the sequential coinjection of a line‐gated plate is investigated numerically, obtaining some important information in the gap‐wise direction, which cannot be caught by 2.5D model. All the numerical results show that the multiphase flow model proposed in this article is effective and can be used to describe the flow behaviors of polymer melt in the SCIM process. POLYM. ENG. SCI. 55:1707–1719, 2015. © 2014 Society of Plastics EngineersKeywords
Funding Information
- National Basic Research Program of China (2012CB025903)
This publication has 38 references indexed in Scilit:
- Effect of crystallographic texture on the anisotropy of Charpy impact behavior in pipeline steelMaterials Science and Engineering: A, 2013
- Influence of temperature and shear rate on the rheology and processability of reprocessed ABS in injection molding processJournal of Materials Processing Technology, 2009
- Effect of molding parameters on the properties of PP/PP sandwich injection moldingsPolymer Testing, 2005
- 3D finite element method for the simulation of the filling stage in injection moldingPolymer Engineering & Science, 1998
- Study of polymer melt flow in sequential injection molding processAIChE Journal, 1996
- Numerical simulation of fiber orientation in injection molding of short‐fiber‐reinforced thermoplasticsPolymer Engineering & Science, 1995
- Numerical Simulation of the Coinjection Molding ProcessJournal of Engineering Materials and Technology, 1993
- Integrated Simulation of Fluid Flow and Heat Transfer in Injection Molding for the Prediction of Shrinkage and WarpageJournal of Engineering Materials and Technology, 1993
- On the Motion of Solid Spheres Falling Through Viscous Fluids in Vertical and Inclined TubesJournal of Fluids Engineering, 1992
- Numerical study of the turbulent flow past an airfoil with trailing edge separationAIAA Journal, 1983