Response Surface Modeling of Ultrasound-Assisted Dispersive Liquid–Liquid Microextraction for Determination of Benzene, Toluene and Xylenes in Water Samples: Box–Behnken Design
Authors:
- 4 May 2012
- journal article
- research article
- Published by Springer Nature in Bulletin of Environmental Contamination and Toxicology
- Vol. 89 (1) , 38-43
Abstract
A simple, fast and effective pre-concentration procedure for the extraction of benzene, toluene and xylenes isomers (BTX) was developed using an ultrasound-assisted dispersive liquid–liquid microextraction coupled with gas chromatography-flame ionization detector in water samples. The effects of different experimental parameters in the extraction step including type and volume of extraction and dispersive solvents, ionic strength, extraction time and sample volume were studied using two techniques, namely one-variable-at-a-time and response surface methodology. The results of “one-variable-at-a-time” showed that the ionic strength and extraction time were not significant on the extraction efficiency. Therefore, a three-factor, three-level Box–Behnken experimental design was employed to optimize the BTX extraction. The optimal conditions were determined to be a volume of extraction solvent (chloroform) of 51 μL, volume of dispersive solvent (methanol) of 514 μL and volume of sample of 12 mL. The enrichment factors of 241.2–305.1, the limit of detections of 205–382 ng L−1 were obtained for the BTX at the optimum conditions. In addition, the relative standard deviations for 50 μg L−1 of the BTX in the water samples were found to be in the range of 1.9 %–5.7 % (n = 5). The developed procedure was then applied for the extraction and determination of BTX in the water samples.Keywords
This publication has 16 references indexed in Scilit:
- A procedure for determination of cobalt in water samples after dispersive liquid–liquid microextractionMicrochemical Journal, 2009
- Ionic liquid-based single-drop microextraction/gas chromatographic/mass spectrometric determination of benzene, toluene, ethylbenzene and xylene isomers in watersJournal of Chromatography A, 2008
- Multivariate optimization of a solid phase microextraction-headspace procedure for the determination of benzene, toluene, ethylbenzene and xylenes in effluent samples from a waste treatment plantJournal of Chromatography A, 2008
- BTEX determination in water matrices using HF-LPME with gas chromatography–flame ionization detectorChemosphere, 2008
- Liquid–liquid extraction/headspace/gas chromatographic/mass spectrometric determination of benzene, toluene, ethylbenzene, (o-, m- and p-)xylene and styrene in olive oil using surfactant-coated carbon nanotubes as extractantJournal of Chromatography A, 2007
- Recent developments in headspace microextraction techniques for the analysis of environmental contaminants in different matricesJournal of Chromatography A, 2007
- Determination of organic compounds in water using dispersive liquid–liquid microextractionJournal of Chromatography A, 2006
- Multivariate optimization and validation studies in on-line pre-concentration system for lead determination in drinking water and saline waste from oil refineryMicrochemical Journal, 2004
- Water solubilization of ethanol and BTEX from gasoline: on-line monitoring by membrane introduction mass spectrometryThe Analyst, 2002
- Static headspace, solid-phase microextraction and headspace solid-phase microextraction for BTEX determination in aqueous samples by gas chromatographyAnalytica Chimica Acta, 2000