Combined Effects of Freestream Pressure Gradient and Density Ratio on the Film Cooling Effectiveness of Round and Shaped Holes on a Flat Plate
- 4 January 2017
- journal article
- research article
- Published by Wiley in Journal of Turbomachinery
- Vol. 139 (4) , 041003
Abstract
The combined effects of a favorable, mainstream pressure gradient and coolant-to-mainstream density ratio have been investigated. Detailed film cooling effectiveness distributions have been obtained on a flat plate with either cylindrical (θ = 30 deg) or laidback, fan-shaped holes (θ = 30 deg and β = γ = 10 deg) using the pressure-sensitive paint (PSP) technique. In a low-speed wind tunnel, both nonaccelerating and accelerating flows were considered, while the density ratio varied from 1 to 4. In addition, the effect of blowing ratio was considered, with this ratio varying from 0.5 to 1.5. The film produced by the shaped hole outperformed the round hole under the presence of a favorable pressure gradient for all the blowing and density ratios. At the lowest blowing ratio, in the absence of freestream acceleration, the round holes outperformed the shaped holes. However, as the blowing ratio increases, the shaped holes prevent lift-off of the coolant and offer enhanced protection. The effectiveness afforded by both the cylindrical and shaped holes, with and without freestream acceleration, increased with density ratio.Keywords
This publication has 19 references indexed in Scilit:
- Film Cooling for Cylindrical and Fan-Shaped Holes Using Pressure-Sensitive Paint Measurement TechniqueJournal of Thermophysics and Heat Transfer, 2015
- An experimental study of density ratio effects on the film cooling injection from discrete holes by using PIV and PSP techniquesInternational Journal of Heat and Mass Transfer, 2014
- Effect of Density Ratio on Flat Plate Film Cooling With Shaped Holes Using PSPJournal of Turbomachinery, 2011
- Gas Turbine Film CoolingJournal of Propulsion and Power, 2006
- A Review of Shaped Hole Turbine Film-Cooling TechnologyJournal of Heat Transfer, 2005
- High-Resolution Measurements of Local Effectiveness From Discrete Hole Film CoolingJournal of Turbomachinery, 1999
- Film Cooling With Compound Angle Holes: Adiabatic EffectivenessJournal of Turbomachinery, 1996
- Film-Cooling Effectiveness Downstream of a Single Row of Holes With Variable Density RatioJournal of Turbomachinery, 1991
- Film Cooling With Large Density Differences Between the Mainstream and the Secondary Fluid Measured by the Heat-Mass Transfer AnalogyJournal of Heat Transfer, 1977
- Heat Transfer and Film Cooling Following Injection Through Inclined Circular TubesJournal of Heat Transfer, 1974