Improvement of shear strength, wood failure percentage and wet delamination of cross-laminated timber (CLT) panels made with superheated steam treated (SHST) layers of larch wood
Authors:
- Yeonjung HanYHYeonjung Han
- Yonggun ParkYPYonggun Park
- Yoon-Seong ChangYCYoon-Seong Chang
- Hyunwoo ChungHCHyunwoo Chung
- Chang-Deuk EomCEChang-Deuk Eom
- Hwanmyeong YeoHYHwanmyeong Yeo
- 22 June 2017
- journal article
- research article
- Published by Walter de Gruyter GmbH in Holzforschung
- Vol. 71 (11) , 873-879
Abstract
Cross-laminated timber (CLT) panels – consisting of several cross-wise stacked layers of glued boards – have a high dimensional stability. However, the outer surfaces of CTL are exposed to environmental humidity changes and thus to swelling and shrinking. To improve CLT’s dimensional stability further, the layers of kiln dried (KD) CLT were substituted partly (on the surfaces) and entirely with superheated steam treated (SHST) wood. The effects of SHST wood and the performance of the one-component polyurethane resin (PUR) were tested by block shear and delamination tests after water soaking. Under various conditions, the shear strength ranged from 1.3 MPa to 4.7 MPa and the wood failure percentage (WFP) from 76% to 92%. The optimal parameter were ascertained as pressing time (30–45 min), pressure (0.98 MPa) and adhesive amount (175–200 g m−2). The water soaked delamination of CLT manufactured with SHST wood was approximately 50% lower than that of CLT made of KD wood.Keywords
This publication has 20 references indexed in Scilit:
- Changes caused by heat treatment in chemical composition and some physical properties of acacia hybrid sapwoodHolzforschung, 2011
- Relations between chemical changes and mechanical properties of thermally treated wood 10th EWLP, Stockholm, Sweden, August 25–28, 2008Holzforschung, 2009
- The effects of heat treatment on some technological properties of Scots pine (Pinus sylvestris L.) woodBioresource Technology, 2008
- Strength properties of thermally modified softwoods and its relation to polymeric structural wood constituentsAnnals of Forest Science, 2007
- Change in mechanical interaction between cellulose microfibril and matrix substance in wood cell wall induced by hygrothermal treatmentJournal of Wood Science, 2006
- Evaluation of heat-treated wood swelling by differential scanning calorimetry in relation to chemical compositionHolzforschung, 2005
- Predicting anisotropic shringkage of softwood Part 1: TheoriesWood Science and Technology, 2002
- A model of anisotropic swelling and shrinking process of woodWood Science and Technology, 2001
- Changes of crystallinity in wood cellulose by heat treatment under dried and moist conditionsJournal of Wood Science, 2000
- Bending strength and toughness of heat-treated woodJournal of Wood Science, 2000