High Performance Anode-Supported Solid Oxide Fuel Cells with Thin Film Yttria-Stabilized Zirconia Membrane Prepared by Aerosol-Assisted Chemical Vapor Deposition
Authors:
- 9 March 2017
- journal article
- Published by The Electrochemical Society in Journal of the Electrochemical Society
- Vol. 164 (6) , F484-F490
Abstract
In this study, we have successfully fabricated yttria-stabilized zirconia (YSZ) electrolyte thin films by aerosol-assisted chemical vapor deposition (AACVD) for solid oxide fuel cells (SOFCs) working at an intermediate temperature range under 600°C. The mix ratio of precursor sources and the deposition temperature of the AACVD process are optimized to obtain target composition and crystal structure of the YSZ film. The optimized AACVD YSZ membrane is incorporated onto Ni-YSZ anodes supported without interlayers for evaluation of SOFC performance. Fully dense 1-μm-thick AACVD YSZ electrolyte successfully produces a stable open circuit voltage (OCV) greater than 1 V at all test temperatures in the range of 450–600°C. Power output of the test cell is measured as about 600 mW cm−2 at 600°C. Performance of our cell is compared to that of a reference cell with the same structure but with an 8-μm-thick membrane produced by screen-printing; our cell produces 1.4 to 4 times as much power as the reference cell at all test temperatures. Electrochemical impedance analysis has confirmed that the power enhancement with the thin AACVD YSZ membrane is due to effective reduction of both ohmic and polarization resistances.Keywords
This publication has 44 references indexed in Scilit:
- Three-Dimensional Nanostructured Bilayer Solid Oxide Fuel Cell with 1.3 W/cm2 at 450 °CNano Letters, 2013
- The effect of an ultra-thin zirconia blocking layer on the performance of a 1-μm-thick gadolinia-doped ceria electrolyte solid-oxide fuel cellJournal of Power Sources, 2012
- Improved Solid Oxide Fuel Cell Performance with Nanostructured ElectrolytesACS Nano, 2011
- Fabrication of micro-tubular solid oxide fuel cells with a single-grain-thick yttria stabilized zirconia electrolyteJournal of Power Sources, 2010
- Review on microfabricated micro-solid oxide fuel cell membranesJournal of Power Sources, 2009
- Atomic Layer Deposition of Yttria-Stabilized Zirconia for Solid Oxide Fuel CellsChemistry of Materials, 2007
- Fabrication and characterization of thin film electrolytes deposited by RF magnetron sputtering for low temperature solid oxide fuel cellsJournal of Power Sources, 2006
- Thin-Film Solid Oxide Fuel Cells on Porous Nickel Substrates with Multistage Nanohole ArrayJournal of the Electrochemical Society, 2006
- Application of novel aerosol-assisted chemical vapor deposition techniques for SOFC thin filmsSolid State Ionics, 2004
- Influence of electrode contacts on conductivity measurements of thin YSZ electrolyte films and the impact on solid oxide fuel cellsSolid State Ionics, 2003